The Building Electrical System Flashcards
Typically, ___________ begins with selection of a
building system voltage, which is dependent on
sizes and types of the connected loads, utilities near
the building, local codes and ordinances,
economics, and safety.
system design
means a ground-mounted or roof-top
distributed solar generation system
designed and installed for residential
applications, which is leased by, or subject
to a power purchase agreement with, the
owner of a residence for the purpose of
generating Electricity for that residence.
Residential Systems
is a single building
that’s set up
accommodate more than
one family living separately.
MULTIFAMILY DWELLING
which has
two dwellings within a single
building, to homes or
small apartment buildings
with up to four units.
duplex
power is brought from a utility transformer to the building service
equipment. It is then divided at a main distribution panel, passes
through individual meters, and is distributed to the individual
dwelling units through feeders.
Multifamily dwelling units
extend from a
panelboard to feed outlets within the unit.
Branch circuits
has
branch circuits that serve common areas (e.g., corridors, laundry
rooms, lobbies, and so forth).
house panelboard
have large and
varied power requirements that necessitate different types of
systems for different building occupancies.
Large commercial and industrial facilities
In a typical large building, _________ is provided to a transformer located outside the building
or it enters a transformer vault located at the service level in
the building.
electrical
power
lines serving a residential development being buried in a trench.
Underground
Electrical Distribution
Lines readied for connection to exterior transformer
Underground Distribution Lines
A 120/240 V-150 A, underground service entrance for a single family residence
Electric meter
Underground service entrance for a multifamily dwelling unit
Electrical meter for multifamily dwelling unit
A service entrance with the electrical meter and main disconnect (below meter and above circuit breakers). Circuit breakers are properly marked on
the panelboard face
Electrical Meter and Main Disconnect
A close-up view of the inside of the panelboard.
paneboard