TB 33 Pneumatic Power Chisel

Question 1

TB 33 Pneumatic Power Chisel

The compressed air aupple of a standard LAFD air bottle. When in continuous operation, it has an approximate working time of two minutes when used with a 30 min bottle, or four minutes when used with a 60 min bottle. It will cut through mild steel plate up to one quarter inch thichk, mild steel bolts to three quarter inch in diameter.

Answer 1

Reference

Question 2

TB 33 Pneumatic Power Chisel

How many sections of air hose and length does the kit have?

Answer 2

Two 25 foot sections

Question 3

TB 33 Pneumatic Power Chisel

The regulators have an outlet pressure of 150 psi. Both regulators are preset at 140 psi. 100 psi working pressure will be supllied at the chisel through the two 25 foot sections of air hose.

Answer 3

Reference

Question 4

TB 33 Pneumatic Power Chisel

Type of chisels and uses.

Cutter: used to remove quarter panels, rocker panels, and inner door panels.

Chisel: used to break spot welds, split nuts, shear hinges and locks. Also used to remove car roofs.

Punch: used to punch out wedged or swelled rivets and trunk lid locks.

Answer 4

Reference

Question 5

TB 33 Pneumatic Power Chisel

What oil is used to lubricate and how many drops do you put in? And how long do you operate the unit for after lubricating?

Answer 5

2 drops of oil #288

Operate for one to two seconds after lubricating.

Question 6

TB 33 Pneumatic Power Chisel

Safety.

Always disconnect the gun from the air supply prior to changing bits.

Station a safety member at the air bottle out of the working area to shut down in the event of an emergency.

Answer 6

Reference