Steps and Numbers Flashcards
What is Seven steps in laser printing:
Cleaning: Drum is cleaned of residual toner and charge.
Step 7
What is Seven steps in laser printing:
Fusing: Fuser assembly uses heat and pressure to fuse toner to paper.
Step 6
What is Seven steps in laser printing:
Exposing or writing: Laser beam writes -100 V image to drum surface.
Step 3
What is Seven steps in laser printing:
Developing: Toner is applied to the surface of the drum.
Step 4
What is Seven steps in laser printing:
Charging or conditioning: Drum surface is charged to -600 V.
Step 2
What is Seven steps in laser printing:
Transferring: The transfer roller puts a positive charge on the paper to pull the toner from the drum and onto the paper.
Step 5
What is Seven steps in laser printing:
Processing the image: Bitmap of the final page is stored in memory.
Step 1
volts * amps = watts
Watt (W) – Measurement of real power use
For Example ,
120V * 0.5A = 60W
Watt (W) – Measurement of real power use
24-pin connector
24 pins
19-pin (Type A) connector
HDMI (High-Definition Multimedia Interface)
DVI Single link connection supports __throughput
3.7 Gbps
DVI Single link allows us to view HDTV at___
60 fps
DVI Dual link connection supports ___throughput
7.4 Gbps
DVI allows us to view HDTV at __
85 fps
- SATA Revision 1.0
- SATA 1.5 Gbit/s, 1 meter
- SATA Revision 2.0
- SATA 3.0 Gbit/s, 1 meter
- eSATA (external SATA)
–Matches the SATA version -
2 meters
- SATA Revision 3.2
- SATA 16 Gbit/s, 1 meter
- SATA Revision 3.0
- SATA 6.0 Gbit/s, 1 meter
The pins on SATA connectors , the smaller __pin connector is used for data transfer. this
7
The pins on SATA connectors , the larger __-pin connector is used to power the device.
15
SCSI Ultra 3 interface. It has __pins on this connector.
68
PATA/IDE ___ pin
40
40 wire cable, the first device that you would connect is referred to as device__ in the PATA standard. And the device connecting on the end of the cable is device____ .
1)0
2)1
80 wire cable, the first device that you would connect is referred to as device__ in the PATA standard. And the device connecting on the end of the cable is device____ .
1)1
2)0
The -wire PATA cable has additional ground wires interleaved between each signal wire. This interleaving helps to reduce crosstalk by providing a more effective shield between the signal wires, isolating them from each other and minimizing interference.
80
In a -wire PATA cable, each wire carries both the signal and a ground reference. However, the ground wires are not interleaved between each signal wire. This layout makes the cable more susceptible to crosstalk because the signal wires are in closer proximity to each other.
40
How many pin in USB-C
24-pin
How many pin in Lighting
8-pin
How many pin in Molex
4-pin
