Practical Drills Flashcards
DRAW a BA board and go from rapid deployment to stage 1 as per exam notes
…
DEMONSTRATE pre entry checks
- don BA set
- cylinder on
- facemask on
- THREE CHECKS!!! LDV, supplementary air and positive pressure
- flash hood on
BUDDY CHECK - helmet on
- tally out, cylinder off and breathe down
- cylinder on, tally in
- gloves on
BUDDY CHECK
report to entry control
DRILL - perform two door entry procedures on different doors, then BA shuffle to a hidden casualty
…
DRILL - walkthrough a BA training scenario from entry control to exiting the building. Simply keep correct comms throughout.
…
DRILL - demonstrate correct gas cooling techniques as you walkthrough a BA training scenario from entry control to exiting the building. Talk through every step.
…
DRILL - Full BA training scenario from pre entry checks, door entry procedures, BA shuffle and good comms throughout.
…
DEMONSTRATE the BA shuffle from standing, kneeling and prone positions
…
DEMONSTRATE the shark technique of cable disentanglement
…
draw a stage II ECP and the different roles
Tie and describe use
BOWLINE
To secure around a stationary object
Tie and describe use
ROLLING HITCH (running end and middle of line)
to tie onto a hose before hauling aloft
Tie and describe use
Round turn and two half hitches
To tie off to a stationary object, example: tying off a line above; lashing a ladder to a building
Tie knot: figure of 8 (and also on the bight) and describe uses
Alternative to overhand knot. Also used to prevent a line unreeving through an eye or block
Tie CLOVE HITCH (running end and middle of line) and describe uses
Secure line to any round object or tool such as axe
Tie SINGLE SHEET BEND