Pike pole, pickhead axe, roof kit Flashcards

1
Q

Purposes/uses of the pickhead axe?

A

Ventilation (sounding, pulling), forcible entry (lock breaking, prying), overhaul, self rescue (brace at window or in wall), search and rescue (probing)

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
2
Q

Weight of pickhead axe?

A

6lbs

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
3
Q

Lengths of pickhead axe

A

32-36 inches

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
4
Q

Handle of pickhead axe made of? Head?

A

Fiberglass (made exclusively for Fireaxe Inc by Nupla) or Tennessee hickory
Head is hand-cast steel

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
5
Q

Nupla is ___, will not ___, will not ___ ___

A

waterproof, warp, conduct electricity

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
6
Q

Use a ___ degree cutting angle when using the pickhead axe

A

60

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
7
Q

Use the top ___ of the blade when cutting with a pickhead axe

A

1/3

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
8
Q

PPE for pickhead axe

A

helmet, gloves, eye protection, TOs or brush jacket

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
9
Q

pickhead axe: ___ before you swing, and make sure your feet are ___-___ back from your target

A

6-12”

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
10
Q

J-hook – pull ___ to roof, inline with the ___ your are trying to release

A

perpendicular, nails

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
11
Q

Self rescue with pickhead axe:

  1. ___ hard using your whole body if you need to ___ while lying down
  2. sink the ___ end into the ___ next to a ___, then cross the ___ with the handle for a strong anchor to tie your ___ on
  3. make a hole in ___, then put the ___ of the pickhead axe down into the ___
A
  1. kip, strike
  2. pick, wall, window, window, dropbag
  3. drywall, handle, wall
How well did you know this?
1
Not at all
2
3
4
5
Perfectly
12
Q

After dumpster fires, ___________

A

make a hole in the dumpster for drainage

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
13
Q

pickhead axe aloft knot:

A

axehead inside a U, dropbag end all the way around, then back through the loop it made

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
14
Q

Cleaning bright metal: remove tar with ___, polish with ___ ___, apply a ___ ___ of ___ ___

A

kerosene, steel wool, light coat of engine oil

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
15
Q

Cleaning Nupla handles:

A

soap and water (Gojo gets used)

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
16
Q

Maintaining wood handles: ___ if needed, ___ lightly, oil with ________

A

scrape, sand, boiled linseed oil

17
Q

Maintaining scabbards:

A

keep clean, rub with neatsfoot oil

18
Q

Purposes/uses for pike pole:

A

overhaul: moving debris and breaking drywall
ventilation: pulling ceiling, sounding, pushing ceiling from above, pulling sheathing

search and rescue: probing

Improvised: breaking glass, hoisting hoselines in open stairwells

19
Q

Who carries axes, pike poles, and rubbish hooks?

A

All trucks and engines carry all three. Trucks will typically have 4-8 pike poles and rubbish hooks, whereas engines will only have 1 of each.

20
Q

Pike pole sizes vs what we carry

A

6, 10, 12, 14, 16, 20 feet / T73 has 6, 12, 16

21
Q

Nupla does not ___ or ___ the yellow handles for conductivity

A

test, rate

22
Q

Nupla handles can handle continuous heat of ___ degrees, and are flame resistant up to ___ degrees. If flame is removed, they will ___-___ and not support ___.

A

250, 800, self-extinguish, combustion

23
Q

6’ pike poles weight approximately ___lbs, with a ___lb head and a ___lb D-handle (so the shaft is about ___lbs)

A

7.5, 2.5, 3.5, (1.5)

24
Q

Pike material is ___ ___ ___, which means the iron has a 2-4% ___ content. The molecular structure ends up being ___ rather than ___, which reduces ___

A

ductile iron casting, graphite, spherical, crystalline, brittleness (cracking and chipping)

25
Shaft of the pike pole is ___ feet long, ___ inches wide. The D-handle is ___ inches long.
5.5', 1.25", 4"
26
Nuplaglass shaft are ___ ___ tubes, reinforced with ___ ___ laid over the exterior in ___ and set in a ___ ___
honeycomb epoxy, fiberglass strands, tension, thermo-set resin
27
The Nupla black stripe is for ______
identifying their proprietary equipment -- they were getting sent other companies' tools for repair, so they added the black fiberglass stripe.
28
Rubbish hook purposes/uses:
ventilation: sounding, pulling roof material, footing while ventilating on steep pitches, punching ceiling from above overhaul: moving debris, pulling drywall rubbish fires: stirring contents breaking glass
29
Rubbish hooks are ___ feet long, ___ lbs total. The head weighs ___lbs.
6, 9, 4
30
Rubbish hook tines are ___ inches long, set ___ inches apart.
7, 6.5
31
Key points when sounding with a rubbish hook: 1. use the ___ of the head 2. keep weight on ___ foot 3. hold the D handle on the ___ so it can't slip out of your hand
1. flat (better feedback to find members) or corner (better power to test integrity) 2. rear 3. side
32
Punching ceilings with a rubbish hook: 1. hold the ___ end 2. get ___, lean ___, look ___
1. hook/tines | 2. low, away, away
33
What to do with a rubbish hook on a rubbish fire?
Stir the contents as they are soaked with water/foam
34
How to break glass with a rubbish hook or pike pole?
stand/look away from the glass, keep the handle horizontal or above end so glass doesn't slide down it
35
Keep tines on a rubbish hook ___
sharp
36
On a roof, walk with a rubbish hook or pike pole ___ so it will ___ if you fall through
horizontally, catch
37
Dropbags: 1. ___' long 2. ___" wide rope 3. ___ braided line 4. __________ attached to one end
150 5/16 Dacron Snap device/clip