Part B

Question 1

Pie equals what?

A) 3.41579
B) 3.14159
C) 3.13159

Answer 1

B) 3.14159

Question 2

For guided bend test discontinuities of

1/32” are.

Answer 2

Acceptable

Question 3

Arc strikes outside the weld grove or area are

Answer 3

Prohibited

Question 4

The sum of the diameters of visible porosity shall not exceed what in any linear inch of weld.
A) 1/8”
B) 1/32”
C) 3/8”

Answer 4

3/8 in 1” of weld.

Question 5

The sum of the diameters of visible porosity shall not exceed what in any linear 12 inches of weld.
A) 1/8”
B) 3/4”
C) 3/8”

Answer 5

B) 3/4” in any 12” of weld.

Question 6

When the weld is transverse to the primary tensile stress in the part that is undercut the undercut shall be no more than

A) 0.010 inches or 0.25mm deep
B) 0.015 inches or 0.29mm deep

Answer 6

A) 0.010 inches or 0.25mm deep

Question 7

Any single continuous 
Fillet weld shall be permitted to under-run the nominal fillet weld size 
specified by...
A) 1/8"
B) 1/6"
C) 1/32"

Answer 7

B) 1/16” under-run

Question 8

Visual inspection of welds in all steels may begin immediately after the completed welds have cooled to
Ambient temperature.
A) True
B) False

Answer 8

A) True
But Final visual inspection of ASTM A514 and A517 steel welds shall be performed not less than 48 hours after completion of weld and removal of preheat

Question 9

Arc strikes outside the weld groove or area or prohibited.

A) True
B) False

Answer 9

A)True

Question 10

Enjoy it’s involving combinations a base metals preheat shall be specified for the higher strength steel being welded.
A) False
B) true

Answer 10

B)True