Normal Procedures Flashcards
What minimum battery voltage should be observed before acceptance?
22.0 V DC
Wait at least _____ minute for APU stabilization before selecting APU bleed air
One
What bleed pressure is required at the ATS (Air Turbine Starter) during engine start?
12 psi minimum (KLA SOP is 21 PSI)
How long can an aircraft be operated after the first occurrence of the blue status message “L or R FADEC MINOR”?
150 hours
What is the lateral wingtip clearance for a 180 degree turn?
97.0 ft
What is the minimum pavement width needed for a 180 degree turn with the nosewheel fully deflected using the tiller?
47 ft 6 inches
When does takeoff inhibit logic occur?
at 70 knots and stop 20 seconds after liftoff or when passing 400 ft AGL, whichever occurs first
If the APU bleed is used during takeoff, when should the switch back to engine bleeds be accomplished?
After passing acceleration height, but no later than 1,500 ft above airport elevation.
How should the APU be shutdown?
The APU bleed and generator should be switched off approximately 1 second prior to pressing the APU STOP button.
When should the APU MASTER button be selected OFF after APU shutdown?
After the APU RPM is below 10%
Wait ____ minutes after the APU MASTER button is selected off before attempting a restart of the APU
Two
During securing, if the OAT is above 35C, wait a minimum of ___ minutes after closing the APU bleed prior to closing the packs.
Two
During the first flight of the day flap test, how long should the flaps remain in the 32 degree position before being retracted?
The flaps must remain in position 32 for a minimum of 10 seconds to allow for complete pressurization of all flap related hydraulic lines
Do not inflate the airfoil deice system at temperatures below ______
-40C (-40F)
When should the airfoil cycle selector be selected to slow mode?
When the SAT is below -20C and the first signs of ice formation are observed when the ICE DETECTED status message illuminates
