MLAG/LACP Flashcards

1
Q

What does MLAG stand for?

A

Multi-Chassis Link Aggregation

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
2
Q

What is MLAG?

A

Active-Active design where two switches look like one. This design utilizes bandwidth from both links to double the bandwidth, rather than having a spanning tree design that would block one link and leave one unused.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
3
Q

What does LACP stand for?

A

Link Aggregation Control Protocol

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
4
Q

What is the main difference between MLAG and LACP?

A

MLAG is an Arista feature that creates a one logical switch using two physical switches.
LACP is a layer 2 protocol that exchanges LACPDUs between switches to form the link aggregation and monitor the links for failures.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
5
Q

What is LACP?

A

LACP, as specified in IEEE 802.3ad, implements dynamic link aggregation and de-aggregation, allowing LACP-enabled switches at both ends to exchange Link Aggregation Control Protocol Data Units (LACPDUs). It is a layer 2 protocol.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
6
Q

What is a MLAG Domain?

A

Pair of two switches (peer switches) and control links that connect the switches.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
7
Q

What is a MLAG Peer?

A

A pair of connecting switches within an MLAG domain.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
8
Q

What is a MLAG Peer Link?

A

The cooperating switches are MLAG peer switches and communicate through an interface. It is a L2 trunk that carries vlans.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
9
Q

What is a MLAG Member Port?

A

One or more physical ports that connect to routers, switches, firewalls, load balancers, and servers.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
10
Q

What is a MLAG VLAN?

A

Vlan used for peers to communicate on the MLAG peer link for communication between them.
Note: Arista uses the standard vlan of 4094, which is a L3 interface. The configuration for the peer link is a point-to-point link between the two switches.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
11
Q

What is a MLAG ACL?

A

Allow MLAG traffic between the two switches. An ACL is configured to allow control plane traffic between the peers. The ACL is already a default preconfigured ACL in read-only access.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly