memory steer (alignment) Flashcards
memory steer is a term used to describe the ______ or _____ of a vehicle caused by faults in the ______ and ________ system
lead
pull
steering
suspension
often a _______ upper strut ____ or ______ gear can cause a pulling condition in one direction after making a turn, as if the vehicle had a ____ and pulled in the same direction
defective
bearing
steering
memory
what is most likely the cause of memory steer?
binding suspension or steering components
to correct memory steer what should be disconneted from where and checked for free rotation
wheels from tie rod end
wheels disconnected from tie rod ends should do what?
rotate easily without bind or roughness
what should be done to components to eliminate binding conditions?
repair or replace
one of the most common causes of memory steer is what?
installation of steering and suspension components with the front wheels turned
most steering and suspension components contains a ________ which has a memory if moved from its install position. if the memory steer condition is only in one direction, then this is the most likely cause.
rubber
the rubber compones experts a _____ on suspension ot steering that causes the vehicle to _____ to one side
force
pull
to test for memory steer perform a _________
test drive
memory test step 1:
with the vehicle _______ at and intersection or in a parking area. turn the _________ completely to the _______ stop then straighten the wheel without going past the ______ ahead position
stooped
steering wheel
left
straight
memory steer test procedure 2
lightly _____ the vehicle and note for any _____ of the vehicle to _____ or ____ to the left
accelerate
tendency
lead
pull
step 3 in memory steer procedure
_____ the procedure turning the steering wheel to the_____
repeat
right
a five wheel alignment includes a check of the ___________
steering wheel
if toe is adjusted without the steering wheel straight what can happen
the wheel will not be straight while the vehicle is straight resulting in the customer believing the vehicle is not aligned
many vehicle manufacturers now include the maximum allowable steering wheel angle variation from straight this specification is commonly?
plus or minus 3 degrees or less