King Air 200 FS Electrical Flashcards
1 What is the rating for the battery?
a. 28 volt, 24 amp hrs
b. 24 volt, 34/36 amp hrs
c. 28 volt, 34/36 amp hrs
d. 24 volt, 42 amp hrs
d. 24 volt, 42 amp hrs
2 Where is the battery?
a. In the left wing center section
b. In the aft compartment
c. In the right wing center section
c. in the nose compartment
c. In the right wing center section
- What is the individual generator rating?
a. 30 volt, 200 amps
b. 24 volt, 300 amps
c. 28 volt, 250 amps
c. 32 volt, 250 amps
c. 28 volt, 250 amps
- Where are the generator switches?
a. Under the gang bar on the overhead pnl
b. On the center instrument panel
c. Under the gang bar on the pilot left subpanel.
c. On the co-pilot sub panel
c. Under the gang bar on the pilot left subpanel.
Under the MASTER SWITCH GANG BAR
- How is a generator turned on?
a. Move the switch to OFF, then ON
b. Hold the switch to RESET for one second then release to ON
c. Move the switch to ON
c. Hold the switch to ON for 1 second.
b. Hold the switch to RESET for one second then release to ON.
- When an engine is being started, in what position should its GEN switch be?
a. RESET
b. ON
c. OFF
c. OFF
- When a generator is off line, what indication is present?
a. An amber L or R GEN light is on
b. No indication is present
c. A green DC GEN light is on
c. A red DC GEN light is on
a. An amber L or R GEN light is on
- Where is the external power receptacle?
a. Under the left wing
b. On the left aft fuselage
c. Under the right wing outboard of the engine nacelle.
d. On the right forward fuselage.
c. Under the right wing outboard of the engine nacelle.
How much continuous power must the external power unit be capable of supplying?
a. 100 amps
b. 300 amps
c. 800 amps
d. 1,000 amps
d. 1,000 amps (300 amps max coninuous)
- What indication is provided to alert the operator that an external power plug is connected to the aircraft?
a. An audible tone
b. An EXT PWR light
c. A master warning light
d. Fluctuating generator meters.
b. An EXT PWR light
- What is the minimum required battery voltage before using an external powwer unit?
a. 28 volts
b. 24 volts
c. 22 volts
d. 20 volts
d. 20 volts
- The BATT switch must be left on during use of external power to?
a. Charge the battery
b. Energize the GCU
c. Power the volt-loadmeters
d. Protect against voltage spikes.
d. Protect against voltage spikes.
- What are the starter limits?
40 seconds on, 60 seconds off.
40 seconds on, 60 seconds off.
40 seconds on, 30 MINUTES off.