K-910 Buster

Question 1

Perform a calibration of the K-910 Buster.

Answer 1

-Place on calibration block
- Press and hold the trigger and wait 2 seconds
- Press and release the LOCK/MODE buttons simultaneously
- Wait 10 seconds (1 beep/second, with a double beep when complete)
- Press and release the MODE button (three beep when complete)
- Release trigger
- Depress trigger to check calibration (reading between 90-110 on calibration block)

Question 2

Put the Buster into each mode and articulate the features of: Raw Data Mode

Answer 2

Default mode and is the baseline at the starting point of the scan

Question 3

Put the Buster into each mode and articulate the features of: Data Scan Mode

Answer 3

With trigger depressed press MODE once. Identical to Raw Data mode but with audible tone upon significant change in density

Question 4

Put the Buster into each mode and articulate the features of: Zero Scan Mode

Answer 4

With trigger depressed press MODE twice. Sets baseline at Zero, and has audible tone upon significant change in density +/- 10

Question 5

Perform a scan in Raw Data or Data Scan Mode, demonstrating the proper technique: Scan Speed

Answer 5

2-3 inches per second

Question 6

Perform a scan in Raw Data or Data Scan Mode, demonstrating the proper technique: Scan Pattern

Answer 6

Grid to search area then cross hair to pinpoint exact location

Question 7

Perform a scan in Raw Data or Data Scan Mode, demonstrating the proper technique: Interpretation of Readings

Answer 7

Higher number = more dense material
Lower number = less dense material

Question 8

Initiate the backlight.

Answer 8

Press and hold trigger
Press & hold the backlight button

Question 9

Demonstrate and explain the purpose of the lock button.

Answer 9

Press and hold the trigger.
Then press and release the Lock Button
Purpose- Allows you to lock the display reading from an area of limited accessibility and limited visibility or in awkward locations where you are unable to see the reading being display.