IBX- Mass Transfer 1-3 Flashcards
Mass transfer rate between two fluid phases does not necessarily depend on the __________ of the two phases.
chemical properties
physical properties
degree of turbulence
interfacial area
chemical properties
In a solution containing 0.30 Kg mole of solute and 600 kg of solvent, the molality is
0.50
0.60
2
1
0.50
Fenske equation determines the
maximum number of ideal plates.
height of the distillation column.
minimum number of theoretical plates.
optimum reflux ratio.
minimum number of theoretical plates.
The term “cooling range” in a cooling tower refers to the difference in the temperature of
cold water leaving the tower and the wet bulb temperature of the surrounding air.
hot water entering the tower and the wet bulb temperature of the surrounding air.
hot water entering the tower and the cooled water leaving the tower.
none of these
hot water entering the tower and the cooled water leaving the tower.
Which of the following is the most suitable for extraction in a system having very low density difference ?
Mixer-settler extractor
Centrifugal extractor
Pulsed extractor
Packed extraction tower
Centrifugal extractor
Total reflux in a distillation operation requires minimum
reboiler load
number of plates
condenser load
all (a), (b) and (c)
number of plates
The amount of steam required per unit quantity of distillate in case of steam distillation will be reduced by
raising the temperature.
lowering the total pressure.
both (a) and (b).
neither (a) nor (b).
both (a) and (b).
The difference of wet bulb temperature and adiabatic saturation temperature of unsaturated mixture of any system is
+ve
-ve
zero
none of these
+ve
Fenske’s equation for determining the minimum number of theoretical stages in distillation column holds good, when the
relative volatility is reasonably constant.
mixture (to be separated) shows negative deviation from ideality.
mixture (to be separated) shows positive deviation from ideality.
multicomponent distillation is involved.
relative volatility is reasonably constant.
When the temperature and humidity of air is low, we usually use __________ draft cooling tower.
natural
forced
induced
none of these
natural
Pick out the correct statement.
In case of liquid-liquid extraction, no separation is possible, if the selectivity of the solvent used is unity.
With increase in temperature, the selectivity of the solvent used in solvent extraction decreases.
The selectivity of solvent used in solvent extraction is unity at the plait point.
all (a), (b) and (c).
all (a), (b) and (c).
__________ columns are used for liquid dispersion in a continuous gas phase.
Packed
Pulse
Bubble cap
Sieve plate
Packed
Overall efficiency of the distillation column is
the ratio of number of ideal plates to actual plates.
the ratio of number of actual plates to ideal plates.
same as the Murphree efficiency.
always more than the point efficiency.
the ratio of number of ideal plates to actual plates.
On addition of solute in the solvent, the __________ of the solution decreases.
boiling point
freezing point
vapour pressure
both (b) and (c)
both (b) and (c)
Which is the controlling factor for a drum drier?
Diffusion
Heat transfer
Both (a) and (b)
Neither (a) nor (b)
Heat transfer
Drying operation under vacuum is carried out to
dry those materials which have very high unbound mositure content.
reduce drying temperature.
increase drying temperature.
dry materials having high bound moisture content.
reduce drying temperature.
Air initially at 101. 3 kPa and 40°C and with a relative humidity of 50%, is cooled at constant pressure to 30°C. The cooled air has a
higher dew point.
higher absolute (specific) humidity.
higher relative humidity
higher wet bulb temperature.
higher relative humidity
Separation of two or more components of a liquid solution can not be achieved by
fractional crystallisation
liquid extraction
absorption
evaporation
absorption
stefan’s law describes the mass transfer by
diffusion
bulk flow
both ‘a’ & ‘b’
neither ‘a’ nor ‘b’
both ‘a’ & ‘b’
At minimum reflux ratio for a given separation
number of plates is zero.
number of plates is infinity.
minimum number of the theoretical plates is required.
separation is most efficient.
number of plates is infinity.
Relative humidity is the ratio of the
partial pressure of the vapour to the vapour pressure of the liquid at room temperature.
partial pressure of the vapour to the vapour pressure of the liquid at gas temperature.
actual humidity to saturation humidity.
none of these
partial pressure of the vapour to the vapour pressure of the liquid at gas temperature.
In batch distillation with constant reflux, overhead product composition __________ with time.
increases
decreases
does not vary
may increase on decrease, depends on the system.
decreases
Psychrometry deals with the properties of gas-vapor mixture. Humidity can be determined by the measurement of the __________ of a fibre.
electrical resistance
thermal conductivity
strength
none of these.
electrical resistance
Heat in BTU necessary to increase the temperature of 1 lb of gas and its accompanying vapour by 1°F is called the
latent heat
humid heat
specific heat
sensible heat
specific heat
To increase the absorption factor, (where, G = gas flow rate, S = solvent flow rate)
increase both ‘G’ and ‘S’.
decrease both ‘G’ and ‘S’.
increase ‘S’ and decrease ‘G’.
increase ‘G’ and decrease ‘S’
increase ‘S’ and decrease ‘G’.
The mass diffusivity, the thermal diffusivity and the eddy momentum diffusivity are same for, NPr = NSc = __________
1
0.5
10
0
1
Dew point of a gas-vapour mixture
increases with temperature rise.
decreases with temperature rise.
decreases with decrease in pressure.
increases with increase in pressure.
decreases with decrease in pressure.
In a packed absorption tower, if the equilibrium and operating lines are both straight lines, then the ratio, HETP/HTUOG __________ the absorption factor.
increases with increase in
is one at unity value of
both (a) and (b)
neither (a) nor (b)
both (a) and (b)
Which of the following plays an important role in problems of simultaneous heat and mass transfer ?
Lewis number
Schmidt number
Prandtl number
Sherwood number
Lewis number
In case of an absorber, the operating
line always lies above the equilibrium curve.
line always lies below the equilibrium curve.
line can be either above or below the equilibrium curve.
velocity is more than the loading velocity.
line always lies above the equilibrium curve.
As the reflux ratio in a distillation coloumn is increased from the minimum, the
slope of the operating line in stripping section decreases.
number of plates decreases very slowly first and then more and more rapidly.
total cost first decreases and then increases.
liquid flow increases while the vapor flow decreases for a system.
total cost first decreases and then increases.
Absorption factor is defined as (where, S1 = slope of the operating line S2 = slope of the equilibrium curve)
S2/S1
S1/S2
S1 - S2
S1 x S2
S1/S2
A plait point is the point on the solubility curve, where the tie line reduces to a point. What is the number of plait point for a ternery system containing twopairs of partially miscible liquids ?
0
1
2
3
0
Which of the following remains constant during sensible cooling process ?
Specific humidity
Partial pressure of vapour
Both (a) and (b)
Neither (a) nor (b)
Both (a) and (b)
Physical absorption is
an irreversible phenomenon.
a reversible phenomenon.
accompanied by evolution of heat.
both (b) and (c)
both (b) and (c)
Make up water is required in a cooling tower to replace the water lost by
evaporation
drift
blowdown and leakage
all (a), (b) and (c)
all (a), (b) and (c)
Which of the following quantities need not be fixed before starting the design of a co-current absorber ?
Heat gain or loss
Flow rate of entering liquid
Flow rate of gas
None of these
Flow rate of entering liquid
Mass transfer co-efficient of liquid is
affected more by temperature than that for gases.
affected much less by temperature than that for gases.
not affected by the temperature.
none of these.
affected more by temperature than that for gases.
Absorption accompanied with chemical reaction is exemplified by the absorption of
ammonia in water.
benzol present in coke oven gas by wash oil.
SO2 in alkaline solution.
all (a), (b) and (c).
SO2 in alkaline solution.
Which of the following unit operations makes use of Thiele-Geddes equation ?
Liquid-liquid extraction
Solid-liquid extraction
Multicomponent absorption with chemical reaction
Multicomponent distillation.
Multicomponent distillation.
Which of the following liquid-vapor contacting devices provides maximum contact surface area for a particular duty ?
Sieve plate column
Bubble cap column
Randomly packed column
Wetted wall column
Wetted wall column
The equipment frequently used for adiabatic humidification-cooling operation with recirculating liquid is
natural draft cooling tower
induced draft cooling tower
spray chamber
none of these
spray chamber
Chemisorption (chemical adsorption) is
same as “Van der Waals” adsorption.
characterised by adsorption of heat.
an irreversible phenomenon.
a reversible phenomenon.
an irreversible phenomenon.
The rate of solid-liquid extraction is limited by the
phase change of the solute as it dissolves in the solvent.
diffusion of the solute through the solvent in the pores to the outside of the particle.
diffusion of the solute from the solution in contact with the particle to the main bulk of the solution.
all ‘a’, ‘b’ & ‘c’.
all ‘a’, ‘b’ & ‘c’.
Raoult’s law applies to the
all liquid solutions
non-ideal solution only.
non-volatile solute.
solvents.
solvents.
In distillation columns, the number of bubble caps per tray primarily depends upon the
allowable liquid velocity.
allowable gas velocity.
allowable gas and liquid velocities.
feed composition.
allowable gas and liquid velocities.
In distillation, overhead product contains
only one component
two components
any number of components
only saturated liquid
any number of components
With increase in pressure, the relative volatility for a binary system
increases.
decreases.
remains same.
either (a) or (b), depends on the system.
decreases.
Low viscosity absorbent is preferred for reasons of
rapid absorption rates and good heat transfer characteristics.
improved flooding characteristics.
low pressure drop on pumping.
all (a), (b) and (c).
all (a), (b) and (c).
Mass transfer co-efficient (K) and diffusivity (D) are related according to film theory as
K ∝ D
K ∝D
K ∝ D1.5
K ∝ D2
K ∝ D
The McCabe Δ L law states that the
molar heats of vaporisation of components are nearly equal.
linear crystal growth rate depends on the degree of supersaturation.
linear crystal growth rate does not depend on the crystal size.
linear crystal growth rate depends on the crystal size.
linear crystal growth rate does not depend on the crystal size.
Bollman extractor
is a static bed leaching equipment.
is used for extraction of oil from oilseed.
is a centrifugal extractor.
employs only counter-current extraction.
is used for extraction of oil from oilseed.
The relation, Sc = Pr = 1, is valid, when the mechanism of __________ transfer is same.
heat and mass
mass and momentum
heat and momentum
heat, momentum and mass
heat and mass
A coalescer in a mixer-settler liquid-liquid extraction coloumn
comprises of thin bed of substances of extended surface having high porosity.
helps in increasing the bubble size entering the settler.
helps in increasing the settling rate of the bubbles.
all ‘a’, ‘b’, & ‘c’.
all ‘a’, ‘b’, & ‘c’.
For the same feed, feed quality and separation (in a distillation column), with the increase of total pressure, the number of ideal plates will
increase
decrease
remain same
data insufficient, can’t be predicted
increase
Pick out the correct statement.
Ponchan-Savarit method is more accurate than McCabe-Thiele method to determine the number of theoretical stages required for the separation of non-ideal binary system by distillation.
A sharp decrease in pressure drop is an indication of flooding in a distillation coloumn.
Solvent used in extractive distillation should be of high volatility.
Flash distillation is suitable for separating components which have very close boiling temperature.
Ponchan-Savarit method is more accurate than McCabe-Thiele method to determine the number of theoretical stages required for the separation of non-ideal binary system by distillation.
When the liquid phase and vapour phase of a binary system obeys Raoult’s and Dalton’s law respectively, the relative volatility is the ratio of
vapour pressure of component A to that of component B.
vapour pressure of component A to the total pressure.
vapour pressure of component A to the partial pressure of A.
partial pressure of component A to the total pressure.
vapour pressure of component A to that of component B.
The operation involved when the soluble material is largely on the surface of an insoluble solid and is merely washed off by the solvent is called
decoction
percolation
elutriation or elution
none of these
elutriation or elution
In the constant rate period of the rate of drying curve for batch drying,
cracks develop on the surface of the solid.
rate of drying decreases abruptly.
surface evaporation of unbound moisture occurs.
none of these.
surface evaporation of unbound moisture occurs.