HSC-22 SOP Chapter III Flashcards
1
Q
HSC-22 SOP Chapter III
A
Armed Helicopter Operating Procedures
2
Q
LASER ENABLE/DISABLE SWITCH
A
HAC shall ensure DISABLE during preflight/hotseat if not used during mission
3
Q
MTS Power up Position
A
STOW
4
Q
Boresight within ___ hours of training/mission
A
24
5
Q
APR 39 and AAR 47 Covers
A
Removed prior to startup
6
Q
After selecting FLIR-ON ____ lapse before ______
A
1 minute before manipulating MTS
7
Q
Arming/De-arming Procedures
ALE 47/AGM-114 CATM/ M-299 Launcher Pins
A
- Taxi clear of line, set parking brake, and AO or ordnance-certified Aircrewmen will remove AGM-114 CATM and M-299 safe pins
- AGM-114 and M-299
- Right seat on the controls, left seat raise hands in the air - ALE 47 Dispensing pins
- Right seat occupies cyclic with right hand, collective with left knee, raise left hand - Co-Pilot Removes CMDS Safe Pin/hands to aircrewmen
- Shipboard = complete immediately prior to take off
After Landing:
- Taxi clear of runway
- Set parking brake
- AO or AO cert aircrewman inserts safe pins
- Shipboard = complete immediately after landing
- Upon shutdown, AO or Aircrewman verify installation of all pins/covers
8
Q
Armed Helo Dual Concurrence
A
Master Arm and Laser Select / type of laser / each time LRD or LTM is fired
9
Q
Master Arm over populated areas
A
Only ELRF
10
Q
Don LEP’s
A
- Boresighting
- LRD LTM operations
11
Q
Firing Log
A
- Range arrival/departure
- Each time Laser is fired/ceased
12
Q
ELRF Targets
A
Nonmanned military targets only
13
Q
USE of Range
A
- Record using DVR and log
- Visual sweep to clear obstacles/Hazards
- Two way comms with all units
- Range is cleared by controller
- Target is acquired, identified, and tracked
- Lasing shall cease if not pointed at target
14
Q
Armed Helo Flight Restrictions
A
- Practice SAS off, Boost off, and single engine landings are prohibited
- DVE/Unprepared authorized (if not initials)
- Autos authorized if FCF auto is briefed and possible excessive rise/decay is addressed
