HMMS Flashcards
What is a primary difference between theSAL and RF missiles
SAL tracks laser energy (passive)
RF tracks reflected RF energy (active)
When are M36 training missile is detected all live missile on board aircraft would display____ in the missile icon
NA
The fuse contains the ARM/SAFE device that arms a missile went its lunch acceleration exceeds approximately____
10 G’s
The AGM-114Rs minimum arming distances is ____ meters
375 meters
The AGM-114K2 arms approximately _____ meters from the launching aircraft
181 meters
When the thrust of the missile exceeds____ to_____ pounds, the missile will launch from the rail
600 to 830 pounds
The AGM-114R missile thrust duration approximately 2.5 to 3.5 second and reaching a maximum velocity of
435 m/s or (845 Kts)
Which component of the M299 launcher contains a training missile emulator which replicates RF missile operation
Launcher electronic assembly(LEA)
Which MPD page allows the air crew to electronically arm the M299 missile launcher
WPN UTIL
What is the minimum altitude to launch a SAL missile
32 Ft
What are the normal pylon articulation limits when the missiles or rockets are action
+4° to -15°
What is a minimum altitude to launch a SAL missile
32 ft
A SAL missile that has not been coded with display an ___ inside the missile icon
L
RF missile that has an over temperature condition with display___ in the missile icon
OT
A Hangfire with display____ in the missile icon in the message HANGFIRE will be displayed in the weapon status section of the high action display for six seconds
MH
RF missile icons have a_____ instead of a straight line at the seeker
V
The SAL missile LOBL Constraints symbology +/- ____ degrees and is being driven by the_____ _____ in the crewmembers display
+/-20 / missile seeker
To prevent video washout by the missile exhaust aircraft should be oriented to____ to ____ to the side from which the missile will be launched
3° to 5°
The ALT channel selection is only available available after a_____ channel has been selected
Priority
The missile quantity defaults to____ for both channels if sufficient missiles are available of the selected warhead
3
The____ ____ button is used to maintain AGM-114R missile in a LOAL flight trajectory
LOBL INHIBIT (L5)
What is the tri-service PRF code range
1111-1788
The AGM-114R missile main warhead default at power up for an armor with a fuse selection of
SQ (Discrete code of 1755)
What negative factor during target illumination will cause a laser energy to be mass within the target
Entrapment
The minimum engagement range to fire an AGM-114K or AGM-114R missile employing the LOBL trajectory is __ meters with a maximum range of ___ km.
500 m/ 7.1 km
The remote designator should not be displaced more than ____ degrees in azimuth from the launch aircraft to target line.
60 degrees
Maximum autonomous designation range is limited by the _______ .
TADS ability to maintain the total laser spot on the target
During a remote designation employing the AGM-114K the remote designator must be positioned outside of the ± ____ ° safety fan either side of the Gunner- Shot Line (GSL).
+/- 43 degrees
Five kilometer engagement, the maximum separation between targets should not exceed ____ meters, with an ____ second separation between missile launches.
100 meters 8 seconds
The ripple mode, after the primary channel missile is launched the alternate channel missile may be launched after ___ seconds separation.
1.5 sec
For an autonomous engagement, the aircraft should be oriented __ ° to __ ° to the side from which the missile will be launched.
3 to 5
The AGM-114L missile MODE selections are ______ in each crewstation.
Common
In the AUTO power mode, the missiles are powered-up at minute intervals.
10 minutes
2nd TARGET INHIBIT selection is used for engagements against ________ targets only.
Stationary
The RF missiles can overheat (OT) if it is radiating (tracking) a target for more than ______ minutes.
3 minutes
With 6 AGM-114L missiles loaded the AUTO power mode selection will power- up ____ RF missiles.
2
The AGM-114L allowable constraints is +/- ____ degrees when tracking the NTS target when the range is less than one kilometer.
5 degrees
Name the three RF missile modes.
STBY, PRE LAUNCH, AND POST LAUNCH
RF missile transfer alignment occurs in the ____ mode.
STBY
In the pre-launch mode, what are the three methods of target handover to the RF missile?
FCR, TADS, AND IDM (RFHO)
Doppler Beam Sharpening (DBS) uses a curved trajectory to induce a relative motion for stationary targets (STI) to enhance the probability of detection and tracking between what ranges?
2500 to 8000 meters
At a range of ___ to ___ meters, targets are too close for a LOAL engagement and must be a LOBL engagement or a “NO ACQUIRE” message will be displayed.
500 to 1000 meters
The three RF missile acquisition modes are ___ , ___ , and ____ .
Terminal track acquisition, pre-Terminal track acquisition, and moving target acquisition
What inhibits can be overridden, and how is this accomplished?
Performance, 2nd detent
Is the message “BACKSCATTER” a safety or performance inhibit?
Safety inhibit
What does the message “ALT LAUNCH” mean?
A rocket launch is in progress. Missiles are inhibited from firing for 2 seconds
What is the RF missile radiation hazard area to be avoided?
1-meter 45 degrees
When in the training mode all tactical missile icons will display _____ inside the missile icon.
NA
The TME allows for thermal management of the missiles by allowing for a cumulative time on of _______ minutes.
30 minutes
With the TRAIN mode selected and a weapon system is actioned the weapons inhibit field will display _____.
Training
With the TRAIN mode selected and the missile system is actioned, the missile constraints box will display a _____ centered in the box.
T
