Flight Management Flashcards

1
Q

Speed will increase over the period of the flight for lower CI values:

A

False.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
2
Q

The method for determining minimum cost speed (ECON speed) is to combine the time related costs and fuel cost for a flight segment. Cost Index (CI) is defined as:

A

A Ratio between time related inflight costs & fuel cost.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
3
Q

You are in RTE page & you entered an OFFSET of 2nm. The OFST light will illuminate on the CDU. IF on an Offset, the airplane will not enter a pre-planned holding pattern (HOLD page).

A
How well did you know this?
1
Not at all
2
3
4
5
Perfectly
4
Q

The FMC position (FMC POS) is a radio updated position, not an IRS position. This DME-DME position is more accurate than an IRU position.

A

True

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
5
Q

The message ‘PURGE UPDATE’ is displayed on the CDU. What does it mean?

A

As FMC automatically checks its position for erroneous radio updates, an error has been detected.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
6
Q

With 3 IRSs available: if any latitude or longitude data from one IRU differs from the weighted average by 30 nm or more for more than 5 seconds, data from that IRU will not be used for the remainder of the flight.

A

True

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
7
Q

A quick alignment take approximately 30 seconds

A

True

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
8
Q

A full alignment of the IRU’s takes approximately ____ minutes.

A

10

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
9
Q

If the message ENTER IRS POS appears after position entry.

A

You should check POS REF 3/3 to verify all IRUs took correct position.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
10
Q

What additional information is displayed on the HSI when the NAVAID switch is ON (Range selector is 40)?

A

The location & identifier of all low & high altitude navaids in the data base within the selected range.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
11
Q

When the HSI is in the MAP mode, how can the distance & ETA to the active waypoint be determined from the map?

A

They appear in the upper LEFT& RIGHT corner of the HSI.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
11
Q

When the HSI is in the MAP mode, how can the distance & ETA to the active waypoint be determined from the map?

A

They appear in the upper LEFT & RIGHT corner of the HSI.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
12
Q

While in HSI PLAN mode, what does the STEP prompt on the CDU LEGS page allow the pilot to do?

A

Step through each waypoint on the route of flight.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
13
Q

The distance & ETA to the active waypoint appear in which of the HSI modes?

A

MAP & PLAN

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
14
Q

If the LEFT FMC fails, how is the First Officer’s CDU affected?

A

The F/O is not affected.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
15
Q

What does the DSPY light on the CDU indicate?

A

The CDU is displaying data not related to the active leg or speed schedule.

16
Q

Which mode control position(s) allow for manual tuning of the DME?

A

VOR or ILS

17
Q

You want to manually tune VOR. To what position should you set the HSI mode selector to activate the VOR/DME panel?

A

VOR

18
Q

When the Range is greater than 40 miles, what happens to the WXR radar display?

A

Doppler radar is deactivated.

19
Q

When dashes appear in the DME, what does it indicate?

A

No computed data for the DME is available.

20
Q

How does the FMC use radio navigation information to update position?

A

Only to update the FMC position, never the IRS position.