Flight deck preflight incl CDL Flashcards
Power up sequence (either pilot). 3 main things
Battery
Check 4 things off - HYD, Wipers, Gear, Flaps
Power up
P2 Preliminary Pre-flight procedure
IRS
STATUS (Fluids - sec eng?, oxy 1600
SCELP
Park Brake Set
P1 FMC Initial setup. 5 steps, check 4 things, set last page
IDENT POS INIT (Time check) ROUTE DEP LEGS to check
POS INIT 2 RNP check
RAD NAV to backup
FIX to backup
VNAV check Trans alt
Perf INIT reserves etc
initial EFB loading 5 items (before you do the formal CDL)
Initialise Flight DOCS, IDENT, SYSTEM NOTAMS and DDG Engine rating check Check ipad for ETP
Pre loadsheet loading of OPT 1
PERFORMANCE COPY FMC DATA XFR to check your mate Agree and then enter r/w, int, etc XFR again to check your mate
What must you have done before stage 2 (loading the box)
Need to have the fuel loaded
What happens at stage 2
Call out ZFW
P2 reads out GW and
P1 checks it against the Taxi weight
THEN CHECK TEMP IN THE BOX is correct
OPT stage 3 - What are the initial actions both of you do?
PERFORMANCE COPY FMC DATA again LOAD CG% CALC CONFIRM PREFERRED INTX AND SELECT IT
OPT stage 3. What does P1 call out and why
Calls out the data in the underlined M for P2 to check his matches.
OPT stage 3. What does P1 do after reading out the M
Calls for P2 to Send to FMC
FMC stage 4 - what FMC pages to have up
P1 Take-off page 1, P2 Page 2
FMC stage 4 - What are the main steps
From U - P2’s screen to me (my CDU) (n) to check it all tallies with the OPT
ACCEPT
Amend the data according to Dispatch Perf Guide
Check Power rating on EICAS
MCP 5 items
ROUTE matches Clearance
WIND REQUEST
FMC Stage 4 what are you amending?
P1 - THRUST LIM - CLB power setting P1 - Show TAKEOFF REF 1 again P2 - TAKEOFF REF 2 Verify climb thrust is displayed P2 - E/O Accel, Accel, THR RED P2 - VNAV CLB page: Speed and alt
