Engines and APU Flashcards
The EEC when operating in the Alternate mode: [8.70.10]
A. Provides no Thrust Limit (overboost) protection.
B. Provides N1 and N2 overspeed protection.
C. Does not allow autothrottle operation.
D. A and B are correct.
D. A and B are correct.
In flight, the EEC selects approach idle if: [8.70.10]
A. Flaps are 25 or greater.
B. RA is below 2500 feet and decreasing.
C. Landing gear is selected down.
D. A and C are correct.
D. A and C are correct.
A low oil quantity condition will be annunciated on EICAS by: [8.70.10]
A. Reverse highlighting (black numbers on a white background) the oil quantity display.
B. An amber OIL QTY (L or R) caution message and associated beeper when
2.0 gallons remain.
C. Oil quantity indicator will change to red and flash.
D. Oil quantity is never monitored.
A. Reverse highlighting (black numbers on a white background) the oil quantity display.
The autostart system monitors ____ during a ground start. [8.70.10]
A. Oil pressure
B. Hot or hung starts
C. Oil quantity
D. A and B are correct
D. A and B are correct
The reverse thrust levers can be raised only when: [8.70.10]
A. The autothrottles are disengaged.
B. Below 100 knots.
C. On the ground with the forward thrust levers in the idle position.
D. None of the above.
C. On the ground with the forward thrust levers in the idle position.
The engine autostart system will make a maximum of three start attempts before aborting the engine start sequence when in flight. [8.70.10]
A. True.
B. False.
B. False.
The APU is operating in the attended mode when: [8.70.30]
A. Either engine is starting or running.
B. One or more of the flight deck seats are occupied.
C. The airplane is in flight.
D. A and C are correct.
D. A and C are correct.
On the ground, the engine autostart system will not attempt a second start after which of the following malfunctions? [8.70.10]
A. No N2 rotation.
B. No oil temperature rise.
C. Loss of both starter/generators.
D. All the above.
C. Loss of both starter/generators.
When the thrust levers are positioned to the full forward position, the____ provides N1 and N2 overspeed protection. [8.70.10]
A. EEC
B. CDU
C. Auto Thrust Limiter System (ATLS)
D. Mechanical Limiters
A. EEC
Manual engine starts are accomplished: [8.70.10]
A. Using the Manual Start supplementary procedure.
B. By turning OFF the AUTO START switch and manually selecting the Start and Fuel Cutoff valves.
C. Manual starts are not available.
D. By coordinating with maintenance via the flight interphone.
C. Manual starts are not available.
Regardless of the EEC switch position, thrust is set using: [8.70.10]
A. N2 as the controlling parameter.
B. Fuel Flow as the controlling parameter.
C. N1 as the controlling parameter.
D. The charted EGT limit.
C. N1 as the controlling parameter.
While operating in the UNATTENDED mode, the APU will shut down for: [8.70.30]
A. An overspeed.
B. High EGT.
C. Speed droop.
D. All the above.
D. All the above.
With the FUEL CONTROL switch in the CUTOFF position, the associated fire switch: [8.70.20]
A. Is automatically unlocked.
B. Requires an active fire signal to unlock.
C. Automatically discharges the first fire bottle when a fire is detected.
D. Resets locked STATUS messages.
A. Is automatically unlocked.
The GEnX 1B76 engines on the 787-9 are rated at: [8.70.10]
A. 69,800 pounds T/O thrust.
B. 84,300 pounds T/O thrust.
C. 76,100 pounds T/O thrust.
D. 90,000 pounds T/O thrust
C. 76,100 pounds T/O thrust.
If an engine indication reaches a redline value, the indicator digital readout, pointer, dial change to a red color. The indicator color change can be reset to white (if the exceeded parameter has returned to normal) by: [8.70.10]
A. Pushing TO/GA.
B. Pushing the Cancel / Recall switch.
C. Selecting the respective Autothrottle disconnect switch OFF then ON.
D. Pushing RESET.
B. Pushing the Cancel / Recall switch.