ECAM Switching Panel Flashcards

1
Q

If the UPPER DISPLAY knob was switched to OFF what would occur?

A

The E/WD display would automatically transfer to the lower display.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
2
Q

With the E/WD displayed on the lower screen, how else can you view SD information?

A

Press and hold the appropriate system button on the ECAM CONTROL panel you wish to view.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
3
Q

How long will this information be available?

A

Max 3 minutes

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
4
Q

What does the ALL pb do?

A
  • Displays ALL the system pages successively in 1-second intervals when held down
  • Release the pb to maintain display of the selected page
How well did you know this?
1
Not at all
2
3
4
5
Perfectly
5
Q

What does pressing the RCL pb?

A

• Allows you to recall any warning or caution messages that the activation of the CLR pb or flight
phase inhibition may have suppressed
• If held longer than 3 seconds, the E/WD will show any caution messages suppressed by the EMER
CANC pb

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
6
Q

If you press the STS pb and the system has no STATUS messages what will be displayed?

A

“NORMAL” for 3 seconds

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
7
Q

If power fails to the ECAM CONTROL panel which buttons are still functional?

A
  • EMER CANC
  • ALL
  • CLR
  • STS
  • RCL
How well did you know this?
1
Not at all
2
3
4
5
Perfectly
8
Q

What does the EMER CANC do?

A
  • Cancels the current Level 1 or 2 warning for the remainder of the flight
  • Cancels the current Level 3 warning for that occurrence
How well did you know this?
1
Not at all
2
3
4
5
Perfectly
9
Q

What do you look for on the FHED check?

A
  • Fuel – fuel quantity, configuration, and balance
  • Hyd – hydraulic quantity
  • Eng – oil quantity above 9.5 quarts + estimated consumption(max .5quarts/hour)
  • Door – doors closed, slides armed, crew oxygen pressure
How well did you know this?
1
Not at all
2
3
4
5
Perfectly
10
Q

What occurs during the Before Takeoff Checklist when the T.O. CONFIG pb is pressed?

A

• The system simulates the application of T.O. power and checks certain systems for proper
configuration
• A warning is displayed if and system is not configured properly
• “TO CONFIG NORMAL” is displayed in the TO MEMO section if the configuration is correct

How well did you know this?
1
Not at all
2
3
4
5
Perfectly