ECAM SWITCHING PANEL

Question 1

With the E/WD displayed on the lower screen, how else can you view SD information?

Answer 1

Press and hold the appropriate system button on the ECAM Control Panel that you wish to view

Question 2

What does the ALL pushbutton do?

Answer 2

a. Displays ALL the system pages successively in 1-second intervals when held down
b. Release the pushbutton to maintain display of the selected page

Question 3

What does pressing the RCL pushbutton?

Answer 3

a. Allows you to recall any warning or caution messages that the activation of the CLR pushbutton or flight phase inhibition
may have suppressed
b. If held longer than 3 seconds, the E/WD will show any caution messages suppressed by the EMER CANC pushbutton

Question 4

If you press the STS pushbutton and the system has no STATUS messages what will be displayed?

Answer 4

NORMAL” for 5 seconds

Question 5

If power fails to the ECAM CONTROL panel which buttons are still functional?

Answer 5

a. EMER CANC
b. ALL
c. CLR
d. STS
e. RCL

Question 6

What does the EMER CANC do?

Answer 6

a. Cancels the current Level 1 or 2 warning for the remainder of the flight
b. Cancels the current Level 3 warning for that occurrence

Question 7

What do you look for on the PRELIMINARY FLIGHT DECK PREPARATION quantity check?

Answer 7

a. ENG – oil quantity above 9.5 quarts + 0.5 quarts per planned flight hours
b. HYD – hydraulic quantity indexes in normal filling range
c. DOOR – oxygen pressure - if half boxed in amber, check the MIN FLT CREW OXY CHART (QRH SUPP DATA)

Question 8

What occurs when the T.O. CONFIG pushbutton is pressed?

Answer 8

a. The system simulates the application of T.O. power and checks certain systems for proper configuration
b. A warning is displayed if and system is not configured properly
c. “TO CONFIG NORMAL” is displayed in the TO MEMO section if the configuration is correct