ECAM SWITCHING PANEL

Question 1

With the E/WD displayed on the lower screen, how else can you view SD information?

Answer 1

Press and hold the appropriate system button on the ECAM control panel that you wish to view

Question 2

What does the ALL push button do?

Answer 2

Displays ALL the system pages successively in 1-second intervals when held down
Release the pushbutton to maintain display of the selected page

Question 3

What does pressing the RCL pushbutton do?

Answer 3

Allows you to recall any warning or caution messages that the activation of the CLR pushbutton or flight phase inhibition may have suppressed
If held longer than 3 seconds, the E/WD will show any caution messages suppressed by the EMER CANC pushbutton

Question 4

If you press the STS pushbutton and the system has no STATUS messages what will be displayed?

Answer 4

“NORMAL” for 3 seconds

Question 5

If power fails to the ECAM CONTROL panel which buttons are still functional?

Answer 5

EMER CANC
ALL
CLR
STS
RCL

Question 6

What does the EMER CANC do?

Answer 6

Cancels the current level 1 or 2 warning for the remainder of the flight
Cancels the current level 3 warning for that occurrence

Question 7

What do you look for on the PRELIMINARY FLIGHT DECK PREPARATION quantity check?

Answer 7

DOOR - Oxygen Pressure: verify that the pressure is sufficient for scheduled flight, refer to Section 2.10 oxygen.
HYD - Hydraulic Quantity: ensure hydraulic quantity indexes in normal filling range (A fluid level above the normal fill range extending up to an equivalent of half the normal range is acceptable)
ENG - Oil Quantity:
If CEO aircraft:
Oil quantity is at or above 9.5 qt + .5 qts per hour of estimated flight time.
If NEO aircraft:
Oil quantity is at or above 9.0 qt + .5 qts per hour of estimated time and not below 10.6 qts. For NEO aircraft, if the engines have been shut down for more than 60 minutes, decrease the required quantities from above by 3 qts to account for oil expansion

Question 8

What occurs when the T.O. CONFIG pushbutton is pressed?

Answer 8

The system simulates the application of T.O. Power and checks certain systems for proper configuration
A warning is displayed if and system is not configured properly “TO CONFIG NORMAL” is displayed in the TO MEMO section if the configuration is correct