ECAM

Question 1

What’s ECAM?

Answer 1

Eletrônico centralized aircraft monitor

Question 2

What E/WD shows ?

Answer 2

Divided 3 sections 
On the top 
Primary engine parameters also thrust 
Fuel indications 
Position of slats and flaps 

Bottom section 
Left side 
Primary failures 
Independent failures 
Menos 
Config menos 

Right side
Special lines
Left part overflow summary
Secondary failures or memos

Question 3

What FWS detect ?

Answer 3

Failure

Question 4

FWS divides their functions according to ten flight phases, what are them ?

Answer 4

Electoral power 
First eng started 
Takeoff power 
80kt 
Lift off 
1500ft or 2 min after liftoff 
800ft on decent 
Touch down
80kt 
2nd engine shut down 
5 min after shut down

Question 5

What are flight phases that FWS not display certain alerts ?

Answer 5

3,4,5, 7 and 8
Take off power 
80 kt 
Liftoff
800ft to decent 
Touch down 
Ecam shows in magenta 
TO inhibit 
LDG inhibit

Question 6

How many level are detected in the FWS according priority?

Answer 6

Level 3 repetitive chime (cRc), special aural alert, master warning, red in the ECAM, system appear on S/D, immediate action

Level 2 single chime, master caution, ecam an amber and system will appear on S/D , not require immediate action

Level 1 no aural alerts and master caution , ecam in amber - just monitoring

Question 7

What are the 3 types of ECAM failure ?

Answer 7

Independent
Amber and not affect other components

Primary
Amber/ red and affect other components or system

Secondary
Amber and affect other system or loss system result of primary failure

Question 8

What happen when ECAM need to show some advisory ?

Answer 8

The title item pulsing and must be monitored

Question 9

When TO appears in the ECAM memo ?

Answer 9

2 min after engine start or when TO CONF pb is pressed when até least one engine is running

Question 10

What TO CONF TEST simulate ?

Answer 10

TO POWER
Pkg brake On
Flex temp not set 
Slats and flaps not in to position 
Pitch trim in not in to position 
Rud trim not in range 
Speed brake not retracted 
Sidestick failt 
Brakes hot 
Doors

Question 11

When LD memo appears !?

Answer 11

During approach 2000ft AGL

Or 750ft AGL if the acft never climb

Question 12

When the ecam memo shows flap conf 3 ?

Answer 12

If the aircraft flight controls are operating in alternate or direct law
Or GPWS LDG FLAP 3 pb is ON

Question 13

The flaps and slats position indications appear in the ?

Answer 13

E/WD

Question 14

If a failure occurs prior to an inhibit phase the EWD displays the warning immediately and will also continue to display it during the inhibited phase and until it is corrected or the crew has cleared it from ECAM.
True or false ?

Answer 14

True

Question 15

When a primary failure is displayed on the left side of EWD you will be able to view a secundar failures on the …..

Answer 15

Right side of the EWD

Question 16

What are the permanents items who shows on the bottom of the SD ?

Answer 16

TAT 
SAT
UTC
GW
If the G loss is less than .7 or greater than 1.4 the G LOAD will be displayed

Question 17

What happened when pilot moves a sidestick more than 30 degrees in pitch or roll or rudder pedal
Deflection more than 22 degrees ?

Answer 17

The FCTL page will appear and the other page will reappears after 20s.

Question 18

When the cruise page appears ?

Answer 18

After 1500ft when land gear are retracted

Question 19

When the sts page automatically appears ?

Answer 19

During flight when the flap handle is positioned at 1

Question 20

When the EWD display the Mainentance Part?

Answer 20

STS flashes

On the ground before engine start or after shut down

Question 21

After a failure of the upper du teh EWD is displayed on the lower DU. How can a pilot display a SD page under this conditions ?

Answer 21

Press and hold the desired SD page button on the ECAM control panel ECP, or press the ND XFR pushbutton