Driving Portion: BRAKE CHECK MEASUREMENT:

Question 1

BRAKE CHECK MEASUREMENT:

Answer 1

• Park on level ground.
• Chock wheels.
• Put into 1st gear.
• Shut off engine, then release clutch.
• Release all brakes. (Push Parking Valves in)
• Mark all Push-Rods with chalk at 0 point, where they go into Brake Canister.
• Apply Parking Brakes (Pull Parking Valves out).
• Measure from chalk mark to brake canister.
• Must be Less than 2”.

Question 2

Parking on Uphill:

Answer 2

• Turn Wheels to Left within 18” of curb.
• Roll unto you touch tire to curb.
• Set Parking Brakes.
• Put into Neutral.

Question 3

How to park on Downhill:

Answer 3

• Turn Wheels to Right within 18” of curb.
• Roll until you touch tire to curb.
• Set Parking Brakes.
• Put into Neutral.

Question 4

DOWNHILL PROCEDURE:

Answer 4

• Stop at brake check or other safe area.
• Check the Brakes.
• Proceed downhill in proper gear at posted speed.
• Do NOT Shift, use Clutch, or use Controlled Braking while scanning for hazards.
• Note: must be able to explain and demonstrate these during driving portion of the test.