Driver Warning Lights Flashcards
Red Flash
Malfunction - Investigate potential faults
Red Illuminated
FIRE - Respond to fire
NBC SYSTEM
Switch (FA19) NBC System set to 1/2 or 1 - Switch off
OPTIC HEAT
Convex mirror ON / (PA31) - switch off
HEATER
Heater ON / (HA23) - Switch Heater OFF, let purge 3 minutes, Master 1 or 2
DRIVER’S FAN
Driver’s heater blower ON (HA24) - Switch off
TURRET FAN
Crew heater blower ON / (HA25) - Switch off
BILGE PUMP CC
Crew compartment bilge pump ON / (HA21) - Switch OFF
BILGE PUMP EC
Engine compartment bilge pump ON /(HA22) - Switch OFF
PREHEATING
Preheating engine (Glowplug) - Release engine start button or press to start
GEAR/STEERING
Steering bow / gear box not in neutral position - Ensure steering bow and gear box are both in Neutral position
HYD PRESS DF
Submergence hydraulic pressure < 105 bar - No deep fording / Switch off engine if deep fording
AIR FILTER
Underpressure signal / Soiled air filter - Clean air intake screens and air filters / test dust ejection blowers for function / reset master switch, report if light still illuminated
TRANS SAFE SW
Fault in the transmission electronics / mode selector shift lock stuck - Push lock button several times / check fuse BE25 / Stop and switch off, reset master switch attempt to operate
ENG MONITOR
Engine control system (ECS) - Stop driving, report fault / (BA6) can be used in an emergency
FUEL LOW
Less than 45L of fuel in the header tank - Check fuel level / Test fuel pumps / Check fuel changeover lever / or use (BA 11)
TRANS TEMP
Transmission oil temp > 128C - Cool transmission by selecting Neutral and running at 1200-1400 RPM for 3 min
TRANS PRESS
Transmission oil pressure too low - Check oil level / check for leakage / refill if required
BRAKE
Parking brake on / malfunction in the service brake - Release park brake / Fault with service brakes, stop driving report fault
BRAKE PRESS
Low fluid level in the central hydraulic system / park brake system below 105 bars / service brake accumulators below 92 bars - Stop, conduct central hydraulic system MIN-MAX tests
OVERSPEED
Engine speed is > 2850 RPM - Reduce engine speed or select a higher gear
COOLANT TEMP
Engine coolant temp is > 110C - Stop, run at 1200 RPM until coolant temp is < 90C or for 5 minutes max
COOLANT LOW
Loss of coolant is > 8L / Loss of coolant is > 17L engine switches off / Possible circulation problem - Circulation problem, reset master switch restart engine / check coolant level, check for leakage, report faults / submersion hydraulics or (BA6) can be used in an emergency
ENG OIL PRESS
Engine oil pressure too low, engine shuts off - Reset master switch, restart engine, check oil level / submersion hydraulics or (BA6) can be used in emergency