Communications Systems Flashcards
What is the purpose of the OBS Audio System switch on the overhead panel? AOM II 5-8
If Captain or FO ACP is inoperative, it allows their audio to be controlled with the Observer’s ACP
When illuminated, what does the Offside Tuning Light indicate? AOM II 5-21
The lighted Radio Tuning Panel is used to tune a radio not normally associated with this radio tuning panel.
The radio normally associated with this panel is being tuned by another radio tuning panel.
How many VHF radios are installed? AOM II 5-22
3 (L, C, R)
With 121.5 selected on the R VHF, can the receiver volume control for that radio be turned OFF? AOM II 5-2
NO, but it can be turned all the way down.
How can you monitor for an IM signal during a CAT II Approach? AOM II 5-2
On ACP, select MKR and push volume knob.
How can we tune Data into the C VHF? AOM II 5-2
Dial above 136.000 or below 118.000 on the big knob and transfer
How is the O2 mask microphone operation verified during preflight? AOM I NP-32
Select FLT microphone on the ACP
Speaker ON
Select Push-to-Test on O2 panel along with Emer knob
Simultaneously press a PTT button (glass shield, yoke, ACP etc…)
On certain aircraft, you must also select OXY on ACP and turn back to BOOM afterwards.
What should we see when pushing the cockpit voice recorder TEST button? AOM I NP-25
Pulsating indications on meter
How many PTT switches are in the cockpit? AOM II 5-21
7-10 depends on aircraft (glare shield x2, yoke x2, ACP x3, hand mic x3)
Selecting the SERV inter phone switch to ON does what? AOM II 5-28
Connects ground crew stations around the aircraft to the Flight Intercom.