Communications Flashcards

1
Q

How many MIC PTT switches does each pilot have?

A

4

-Only place with INT PTT is ATP and control wheel.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
2
Q

What controls true switching of Boom and Oxygen mask mic?

A
  • Left oxygen stowage box.
  • Oxygen mask mic activates when left hand door is open.
  • Open: oxygen mask mic enabled, boom mic disabled.
  • Closed plus reset: Oxygen mask mic disabled, Boom mic enabled.
How well did you know this?
1
Not at all
2
3
4
5
Perfectly
3
Q

What is recorded by the cockpit voice recorder?

A
  • Transmitted or received datalink communications and flight deck audio as selected on the audio control panels.
  • Flight deck area conversations.
How well did you know this?
1
Not at all
2
3
4
5
Perfectly
4
Q

How is HF 1 sensitivity set?

A
  • Sensitivity can be adjusted using any radio tuning panel with the receiver selected.
  • Sensitivity control is rendered inop by radio tuning panel failure.
How well did you know this?
1
Not at all
2
3
4
5
Perfectly
5
Q

How do you identify that the HF transceiver fails to tune?

A

Tone lasting longer than 7 seconds.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
6
Q

Which VHF or HF system can be used for ACARS communication?

A

All: VHF: (L, C, R) HF: (L, R)

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
7
Q

When does the VHF stuck mic protection operate?

A

On the Ground: and VHF transmission lasting longer than 35 seconds is disabled following annunciation of an audio tone.

In flight: 30 seconds, but you must manage it, does not disengage automatically.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
8
Q

SELCAL monitors which radio system?

A

VHF and HF radios.

-Must have frequency tuned to that station.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
9
Q

Does an incoming SELCAL trigger any dotted EICAS message and aural alert?

A

Call light illuminates and chime sounds.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
10
Q

How is a SATCOM call initiated and answered?

A

Using CDU and answered automatically. Speak using mic.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
11
Q

When will SATCOM call light extinguish?

A

Ground party hangs up or pilot ends call on CDU

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
12
Q

How is communication established with the ground engineer?

A

Select GND on aft aisle stand call panel and speak through flight inter phone.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
13
Q

What are the indications of a call from the ground crew?

A
  • Aural alert chime.

- Illumination of FLT call indication on audio control panel.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
14
Q

How can the service interphone be used from the flight deck?

A

System can be connected to the flight interphone system through the service interphone switch on the overhead panel.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
15
Q

Which areas are covered by PA?

A

Upper deck seating area plus crew rest area.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
16
Q

How are ATC uplink messages annunciated in the flight deck?

A

EICAS “ATC MESSAGE” and a high level aural chime, ATC message block.

17
Q

How are company uplinked messages annunciated in the flight deck?

A

COMM communication message and aural chime.

18
Q

What EICAS memo message will shownof VHF or HF radio is not available for ACARS?

A

HF DATA OFF

VHF DATA OFF