Chapter 96,97 Flashcards
0
Q
When air is forced through a heating coil, where the fan and coil are within the same unit, the unit is known as: A) a unit heater B) an injector C) a diverted D) a convector
A
A) a unit heater
1
Q
Convectors use \_\_\_\_\_\_ to increase heat transfer. A) metal fins B) a fan C) larger surfaces d) glycol/water mix
A
A) metal fins
2
Q
A radiator trap is a device used to: A) allow only air to leave the radiator B) vent steam from the radiator C) depressurized a radiator D) allow only water to leave the radiator
A
D) allow only water to leave the radiator
3
Q
The exhausted on an air separation tank consists of a series of \_\_\_\_\_\_ through which water is forced by the pump. A) rings B) nozzles C) Venturi tubes D) valves
A
B) nozzles
4
Q
Which of the following pieces of equipment is not a source of heat? A) radiator B) convector C) air vent D) unit ventilator
A
C) air vent
5
Q
In a gravity return system, the boiler should be placed: A) well above the highest radiator B) well below the lowest radiator C) on an elevated platform D) at the same level as the radiators
A
B) well below the lowest radiator
6
Q
A pressure balancing device that prevents the boiler pressure from forcing the water in the boiler into the return line is called a: A) pressure equalizer B) bleed valve C) Hartford loop D) pressure control valve
A
C) Hartford loop
7
Q
If the water level falls too low during operation of a steam heating boiler, the operator should:
A) lower the flame and add water to bring it up to a safe level
B) add more water immediately
C) operate the safety valve
D) shut down the boiler
A
D) shut down the boiler
8
Q
Steam in a two pipe, vacuum return system is supplied at a maximum pressure of: A) 75 kPa (10 psi) B) 50 kPa (7 psi) C) 200 kPa (30 psi) D) 103 kPa (15 psi)
A
D) 103 kPa (15 psi)
9
Q
A vacuum pump maintains a vacuum \_\_\_\_\_\_ kPa higher in the condensate return system than in the supply main. A) 3-5 B) 7-10 C) 12-16 D) 20-25
A
B) 7-10
10
Q
Causes of insufficient steam supply to the heating units can be attributed to: A) improper pitch B) defective radiator valve C) clogging of connections and valve D) all of the above
A
D) all of the above