Chapter 9 - Emergency Procedures (W/C/N)

Question 1

[CAUTION] When shutting down an engine that has malfunctioned in flight, it is important to ______.

Answer 1

identify the malfunctioning engine to avoid shutting down the wrong engine

Question 2

[CAUTION] Monitor TGT after shutdown. If TGT rises above ____, or there is evidence of _____ as indicated by _______, place the ENG START switch in _______.

Answer 2

[CAUTION] Monitor TGT after shutdown. If TGT rises above 540C, or there is evidence of combustion as indicated by a rapid rise in TGT, place the ENG START switch in IGN ORIDE position and motor engine until TGT decreases below 540C.

Question 3

EMERG ENG SHUTDOWN is defined as _________. Engine shutdown in flight is not usually an immediate action item unless a fire exists. Before attempting shutdown, identify the affected engine by checking _____.

Answer 3

an engine shutdown without delay.

engine-out warning messages on the EUFD and observe the ENG page for TGT, Np, Ng, TQ, and OIL PSI.

Question 4

If emergency egress is required before the rotor blades have stopped, ensure _______ and ______ to prevent rotors from striking personnel/fuselage/ground.

Answer 4

MSTR IGN - BATT

cyclic remains centered

Question 5

[WARNING] To prevent eye injury, pilot and CPG helmet visors should be _______. Debris may be expelled 50 feet outward.

Answer 5

down prior to canopy jettison

Question 6

[NOTE] Only the crew station arming the STORES JETTISON panel can _____ it. Once armed, _______ can activate jettison.

Answer 6

dis-arm

either crew station

Question 7

[WARNING] Ensure aircraft controls are configured for __________ prior to pressing the FIRE pushbutton.

Answer 7

single engine operation

Question 8

[WARNING] Pressing the FIRE pushbutton (whether illuminated or not) will _________. This action can only be reversed from the same crew station.

Answer 8

shut off fuel to the selected engine or APU

Question 9

[NOTE] FIRE pushbuttons remain illuminated until ________. For a crew station to reset the system, that crew station FIRE pushbutton must be deselected.

Answer 9

sensors no longer detect a fire

Question 10

What 6 things happen when an illuminated FIRE pushbutton is pressed?

Answer 10

• arms the fire extinguishing system
• shuts off fuel to the engine/apu
• shuts off bleed air from the engine/apu
• closes fire louvers for the engine
• stops voice warning message
• extinguishes MSTR WARN light