Chapter 8 - Normal Procedures

Question 1

[WARNING] All ____ and ____ safety pins shall be installed when the helicopter is on the ground and removed before flight.

Answer 1

ASE and pylon safety pins

Question 2

[WARNING] During preflight, and after all live fires when the AWS was used, ________.

Answer 2

the barrel shall be inspected for cracks

Question 3

[NOTE] When icing conditions exist, or are predicted, and hellfire operations are expected, the launcher ______ switch located on each launcher must be manually placed in the _____ position prior to launch.

Answer 3

ARM/SAFE

ARM

Question 4

[CAUTION] Closing ___ or more gaspers will cause the blower to operate in a stall region, increasing noise levels. Operating with ____ gaspers closed may cause the blower to overheat and shut down.

Answer 4

2 or more gaspers closed

all gaspers closed

Question 5

[CAUTION] To prevent heat damage to the SP, the APU must be started within ____ of the initiation of batter operations when FAT > ___C, within ____ when FAT is between ___ and ___C, and within ____ when FAT is < ___*C

Answer 5

1 minute, FAT >43C
3 minutes, FAT 32-42C
20 minutes, FAT < 32*C

Question 6

[WARNING] Do not start engines with ____ engaged.

Answer 6

BUCS. (run FLT CNTRLS IBIT to clear the faults)

Question 7

[NOTE] Some thru-flight data will be lost unless the THRU-FLIGHT button is selected within ____ of power up.

Answer 7

one minute

Question 8

[NOTE] Maintenance action is required after ______ of the Flight Controls IBIT.

Answer 8

2 consecutive failures

Question 9

[CAUTION] In the event that one or both EGIs will not align after initial startup or after performing ON-Ground Manual Reset and Alignment Procedures, the _________.

Answer 9

aircraft shall not be flown until cleared by maintenance personnel.

Question 10

[WARNING] Aborted starts may cause fuel to collect in the engine nacelle. Subsequent engine starts may only be performed after _____.

Answer 10

the nacelle door / work platform is opened and the nacelle is inspected for fuel. If during the initial start an abnormal TGT rise was evident, or fuel is evident in the nacelle, the ignition system shall be checked IAW standard maintenance procedures.

Question 11

[CAUTION] Rotor locked engine starts shall not be performed with a rotor blade _______.

Answer 11

directly over the exhaust of the engine being started.

Question 12

[CAUTION] During a rotor brake LOCK start, if rotor blades begin to rotate: Set RTR BRK switch to - __.

Answer 12

OFF

Question 13

[NOTE] Use of the inlet button while starting engines is to alleviate _______ while starting warm engines. The pilot ______ anytime a warm engine start is required.

Answer 13

compressor stalls

will use this button

Question 14

[CAUTION] If engine 1 or 2 start advisory remains displayed after 66-68% Ng; Position ENG START switch to ____, then ____.

Answer 14

IGN ORIDE

OFF

Question 15

[CAUTION] TGT must be less than ____ before moving power lever to IDLE

Answer 15

80*C

Question 16

[CAUTION] If an engine indicates near ___ Torque, ______.

Answer 16

0% torque, retard POWER lever of affected engine to OFF

Question 17

[NOTE] Hit Checks, TQ should be below ___ after engine is brought to IDLE. If torque does not go below __, wait 5 minutes and if torque still does not drop below ___ do not fly the aircraft.

Answer 17

5%

Question 18

[WARNING] Do not cycle anti-ice bleed and start valve more than ____ to determine proper operation. Do not fly the aircraft if TGT rise is less than ____ or switch cycling is required.

Answer 18

once

50*C

Question 19

[CAUTION] To prevent damage to the engines, the engine anti-ice system shall be manually activated when the aircraft is flown in visible moisture and FAT is less than ___.

Answer 19

+5*C

Question 20

[CAUTION] Excessive forward cyclic displacement with low power settings will result in ______.

Answer 20

high strap pack loads

Question 21

[NOTE] Anytime the load or environmental conditions increase significantly (____ lbs, __*C, or ____ ‘ PA), the aircrew will perform additional power checks.

Answer 21

1,000 lbs
5*C
1,000’ PA

Question 22

[NOTE] Prior to landing, external stores may be placed in the _____ position.

Answer 22

GROUND STOW

Question 23

[CAUTION] Care shall be exercised when operating the helicopter on rough terrain to prevent damage to the _____.

Answer 23

underside antennae