Chapter 7 Flashcards
How many devices can a Bluetooth device connect to simultaneously?
7
A device has an IPv6 address of 2001:0DB8:75a3:0214:0607:1234:aa10:ba01 /64. What is the host identifier of the device?
0607:1234:aa10:ba01
Which layer of the OSI model is responsible for logical addressing and routing?
network
What is the correct order of the layers of the TCP/IP model from the top layer to the bottom?
application
transport
internet
network access
What TCP/IP model layer is responsible for MAC addressing?
Network access
Which two layers of the OSI model correspond to the functions of the TCP/IP model network access layer? (Choose two.)
Physical
Data Link
What is identified by the 100 in the 100BASE-TX standard?
The maximum bandwidth in Mb/s
Which two characteristics describe Ethernet technology? (Choose two.)
It uses CSMA/CD access control method
It is supported by IEEE 802.3 standards
Which IEEE standard operates at wireless frequencies in both the 5 GHz and 2.4 GHz ranges?
802.11n
A customer is considering a multipurpose device to create a home network. Which three devices are usually integrated into a multipurpose network device? (Choose three.)
Router
Wireless Access Point
Switch
Which network device makes forwarding decisions based on the destination MAC address that is contained in the frame?
Switch
Which pairs of wires change termination order between the 568A and 568B standards?
green and orange
Which two types of signal interference are reduced more by STP than by UTP? (Choose two.)
RFI
EMI
How many host addresses are available on a network with a subnet mask of 255.255.0.0?
65,534
What is a characteristic of the UDP protocol?
low overhead
types of coaxial cable used for networks
thicknet / thinnet
types of coaxial cable used for television
RG59 / RG6
wiring standards for twisted-pair cabling
T568A / T568B
connector for twisted-pair cables
RJ45
types of interference that affect the quality of data transmission
EMI / RFI
types of twisted-pair cables that are commonly used for cabling local networks
UTP / STP
category ratings for twisted-pair cables that specify number of wires and twists and affects distance limitations
CAT5e / CAT6 / CAT7
cables with shielding made from a special plastic that retards fire
plenum
classifications of fiber cables that signify light source, distance limitations, and speed
single-mode / multi-mode
fiber connector that accepts both the sending and receiving fibers
duplex multimode LC connector
characteristic of media that allows data to flow in both directions at the same time or one direction at a time
duplex
network covering a small geographic area typically owned by an individual
LAN
network that is owned by an ISP or corporations and covering a wide geographic area
WAN
a network connecting peripherals such as mice, printers, and smartphones to a single host, typically using Bluetooth technology
PAN
a network that spans a large campus or city and that interconnects buildings through wireless or fiber optic backbones
MAN
architecture designed to handle collisions by controlling how devices communicate on an Ethernet network
CSMA/CD
types of encryption used on wireless networks
WEP / WPA2
predefined numbers that identify commonly used protocols such as FTP, SSH, HTTP, and DNS
TCP/UDP port numbers
intermediary devices used in a LAN to connect hosts and forward data to other devices
hub / bridge / switch
layered reference models that prepare data for transmission
OSI / TCP/IP
a device that connects wireless hosts to the network via the use of radio waves
wireless access point
a device that connects networks and forwards traffic from hosts to remote networks through the use of IP addresses
router
software or hardware that permits or denies traffic in order to protect data and equipment from unauthorized access
firewall
devices that regenerate a weak signal to extend the distance that data can travel
repeaters
DC current is transferred over Ethernet cable, along with data, to power PoE devices
PoE
48-bit address hardcoded onto the NIC and usually represented in hexadecimal format
MAC
32-bit address assigned to a host and usually represented in dotted decimal format
IPv4
128-bit address assigned to hosts and represented in hexadecimal format
IPv6
32-bit value used with an IPv4 address to indicate network and host components
subnet mask
protocol that dynamically assigns IP addresses to hosts
DHCP
Which layer of the OSI model is responsible for logical addressing and routing?
transport
Which three layers of the OSI model map to the application layer of the TCP/IP model? (Choose three.)
presentation
session
application
What TCP/IP model layer is responsible for MAC addressing?
network access
Which two layers of the OSI model correspond to the functions of the TCP/IP model network access layer? (Choose two
Physical
Data
Which two characteristics describe Ethernet technology? (Choose two.)
It uses the CSMA/CD access control method.
It is supported by IEEE 802.3 standards.
A customer is considering a multipurpose device to create a home network. Which three devices are usually integrated into a multipurpose network device? (Choose three.)
Router
Switch
Wireless Access Point
Which network device makes forwarding decisions based on the destination MAC address that is contained in the frame?
Switch
What device uses IP addresses to forward traffic from one network to other networks?
Router
Which term describes a type of coaxial cable?
RG-6
Which pairs of wires change termination order between the 568A and 568B standards?
Green and Orange
Which two types of signal interference are reduced more by STP than by UTP? (Choose two.)
RFI
EMI
What is a characteristic of the UDP protocol?
Low Overhead
Which three layers of the OSI model map to the application layer of the TCP/IP model? (Choose three.)
session
presentation
application
Which two layers of the OSI model correspond to the functions of the TCP/IP model network access layer? (Choose two.)
data link
physical
Which two characteristics describe Ethernet technology? (Choose two.)
- It is supported by IEEE 802.3 standards.
- It uses the CSMA/CD access control method
Which pairs of wires change termination order between the 568A and 568B standards?
green and orange
A technician is troubleshooting a problem where the user claims access to the Internet is not working, but there was access to the Internet the day before. Upon investigation, the technician determines that the user cannot access the network printer in the office either. The network printer is on the same network as the computer. The computer has 169.254.100.88 assigned as an IP address. What is the most likely problem?
The computer cannot communicate with the DHCP server