Chapter 1: Legislation and Codes for Power Engineers Flashcards
What is the main focus of the National Board of Boiler and Pressure Vessel Inspectors (NBBI)?
Select one:
A.
To supervise the Power Engineers and the safe, and efficient, operation of the plant
B.
To establish uniform qualifications for inspectors and acceptance of standard code requirements
C.
To regulate safe handling of fired equipment
D.
To state the minimum qualifications necessary to obtain each class of Power Engineer certification
E.
To regulate fire safety in the plant
B.
To establish uniform qualifications for inspectors and acceptance of standard code requirements
A2C01Q05 What activity restores a boiler to its original condition as per the manufacturer’s data report?
Select one:
a.
A restoration
b.
A retro-fit
c.
An alteration
d.
A repair
d.
A repair
A2C01Q16 What does CSA-B51 say when a solid fuel boiler that is operating at a pressure over 103 kPa is provided with a fusible plug?
Select one:
a.
The plug should be constructed of a non-eutectic alloy
b.
The plug must be designed as specified in the ASME Code
c.
The plug must be removed daily
d.
The plug must be reinforced
b.
The plug must be designed as specified in the ASME Code
The pressure vessels section of CSA-B51 identifies pressure vessels and their installation, including pressure vessel inspection openings. This section also shows the design of cushion tanks, blowoff vessels, and the installation of:
Select one:
a.
Air receivers
b.
Boiler drums
c.
Deaerators
d.
Blowdown tanks
e.
Fuel tanks
a.
Air receivers
A2C01Q08 Which ASME BPVC code section contains Recommended Rules for the Care and Operation of Power Boilers?
Select one:
a.
Section IX
b.
Section IV
c.
Section VI
d.
Section VII
d.
Section VII
A2C01Q15 According to CSA-B51, when the top connection of a water gauge is more than 2 m and less than 6 m from the floor or working platform of a boiler room, what must it be fitted with?
Select one:
a.
Bars and beams
b.
A ladder
c.
A relief valve
d.
Rods or chains
d.
Rods or chains
What code contains Recommended Guidelines for the Care of Power Boilers?
Select one:
A.
CSA-B52
B.
ASME BPVC, Section I
C.
CSA-B51
D.
ASME BPVC, Section VII
E.
NFPA-1001
D.
ASME BPVC, Section VII
A2C01Q16 What type of additional requirement is necessary for ammonia refrigeration systems?
Select one:
a.
There must be a control panel that is painted red
b.
There shall be a closed ventilation system in operation
c.
Centrifugal compressors only must be installed
d.
The system must be installed in a Class T machinery room
d.
The system must be installed in a Class T machinery room
Which of these is the Boiler, Pressure Vessel, and Pressure Piping Code?
Select one:
A.
CSA-B52
B.
ASME BPVC, Section I
C.
ASME BPVC, Section VII
D.
CSA-B51
E.
NFPA
D.
CSA-B51
A2C01Q12 What is another term for the fabrication inspection of a boiler or pressure vessel?
Select one:
a.
Shop inspection
b.
In-service inspection
c.
Interim inspection
d.
Company inspection
a.
Shop inspection
