Chap 22 & 23 cutting tool materials/fluids and machine process

Question 1

Process Used to create a round hole, usually by means of a rotating tool that has two cutting edges

Answer 1

drilling

Question 2

Machining process used to enlarge a hole made by a pervious process

Answer 2

boring

Question 3

Machining process used to make an existing hole dimensionally more accurate than can be achieved by drilling

Answer 3

reaming

Question 4

Machining process used to produce external or internal threads

Answer 4

tapping

Question 5

Machining process used to produce textures on cylindrical surfaces

Answer 5

knurling

Question 6

Workholding device on a lathe that tightly clamps a cylindrical end of a workpiece to the spindle using three or four jaws

Answer 6

chuck

Question 7

Lathe component that is fixed to the upper left portion of the bed and is equipped with motors, pulleys, and belts that supply power to the spindle at various rotational speeds

Answer 7

headstock

Question 8

Lathe component that slides along the ways and is usually on top of the right side of a lathe; it can be clamped/fixed at any position along the ways and is equipped with a center (i.e. small. conical protrusion) that supports the right end of a long workpiece that is being turned in a lathe

Answer 8

tailstock

Question 9

Large assembly or tray that slides along the ways and is usually on top of the center portion of a lathe; it consists of tool post upon which the cutting tool is mounted, a cross slide that moves (radially) in and out (perpendicular to the ways) to control the distance from the cutting tool to the center of the part being turned, and a front panel (i.e. apron) on which the controls for both the manual and automatic movement of the carriage reside

Answer 9

carriage