Ch 12 quiz Flashcards
What is always required to achieve connectivity to the WLAN?
The proper signal strength when compared to the noise floor
The built-in macOS supplicant
External antennas
No interference
The proper signal strength when compared to the noise floor
What is the key factor in achieving a particular data rate?
The transmit power at the AP
The transmit power at the client
That antenna gain on the AP
SNR
That antenna gain on the AP
What is the best way to ensure you have cell overlap?
Measure the percentage of overlap with a ruler
Ensure multiple APs are visible at cell boundaries
Disable RRM
Enable ARM
Enable ARM
what is the maximum acceptable unidirectional delay in milliseconds for most volp implementations?
a. 300
b. 200
с. 150
d. 100
150
You have detected interference cause by one AP on channel 11 and another on channel 2. What kind of interference is this?
Non-Wi-Fi
CCI
Adjacent non-overlapping channel
Adjacent overlapping channel
Adjacent overlapping channel
Which one of the following actions may resolve non-Wi-Fi interference problems?
Move the local BSS to a different channel
Decrease the output power on the AP
Use external antennas on the client
None of these
Move the local BSS to a different channel
What kind of interference may occur if an AP on channel 6 is configured with 400 mW of output power and another AP is a few feet away on channel 1?
CCI
Non-Wi-Fi
ACI
Full-time interference
ACI
What example tool can be used for load testing?
WLAN Killer
Spectrum analyzer
Protocol analyzer
WiFi Scanner
WLAN Killer
What simple networking tool can verify network connectivity?
PING
Protocol analyzer
Spectrum analyzer
IPCONFIG
PING
What is an example of an application that can test throughput, use only UDP, and simulate Voice QoS traffic?
PING
WAN Killer
TamoSoft Throuhgput Test
TRACERT
TamoSoft Throuhgput Test
