Caution/Danger Flashcards

1
Q

A good indicator that all of the moving parts are getting lubrication is when the oil pressure gauge reads at least ____

A

12 psi at idle speed

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
2
Q

If there is no oil pressure indicated within _____ , stop the engine and check the lubricating system

A

10 to 15 seconds

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
3
Q

Pressure should not fall below ___ at 1800 rpm

A

28 psi

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
4
Q

Check engine oil level and inspect for any signs of _______

A

contamination, fuel, coolant or debris

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
5
Q

During long engine idling periods with transmission in nuetral, the ____ may fall below the normal operating range

A

engine coolant temperature

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
6
Q

Incomplete combustion of fuel can cause ____

A

crankcase dilution, formation of lacquer or gummy deposits on the valves, pistons and rings and rapid accumulation of sludge in the engine.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
7
Q

When on scene with all warning lights activated, engage the engine high idle feature. Doing so will assist the ____

A

the alternator with keeping up with the electrical current demands

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
8
Q

Stopping a turbocharged engine immediately after high speed operation may cause damage as it continues to turn without ______

A

an oil supply to the bearings

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
9
Q

Stoping turbocharged engines immediately causes ___

A

failure of turbo seals and or bearings

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
10
Q

Try not to sou down the engine unless coolant temptation is

A

195 degrees or less

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
11
Q

Each stage of the Telma draws approximately ___

A

50 to 60 amps

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
12
Q

All four stages of the telma draws approx ____

A

250 amps

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
13
Q

The first electrical load to be shed will be the ____. turns off when the voltage drops below___

A

air conditioning / 12.8 volts

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
14
Q

Never set outrigger jack over a _____, beams should not ____

A

storm drain or manhole cover / bridge the street and the curb

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
15
Q

Do not operate the ladder elevated in wind conditions exceeding ___

A

30 mph

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
16
Q

Greatest reach with aerial is attained over the ___

A

Side

17
Q

Best stability is over the ___

A

Rear, with the rear tire tracks or 45 degree to either side

18
Q

Locking pins: Allow _____ minimum clearance above the locking pin when inserted through the holes in the skirt

A

1/4”

19
Q

If angle of turntable is between ________, reduce capacities by 50%

A

6% and 14% / 3.5* and 8*

20
Q

To cage spring breaks, unscrew the ____ located at the end of the spring brake chamber using a ____

A

1/2” diameter bolt / 3/4” box end wrench

21
Q

Batteries give off ___ gas

A

hydrogen

22
Q

To avoid damage to the vehicle electronic components voltage supplied to a vehicles electrical system must not exceed ____

A

16 volts