ATM Standards Flashcards
Plan a VFR flight
Aircrew is capable of completing the flight
Determine if it can be completed under VFR
Determine the departure, enroute, and arrival procedures
Select routes and altitudes
Determine distance +/- 1 NM
Determine TAS +/- 5kts
Determine GS +/- 5 kts
Determine ETE +/- 1 min
Determine heading +/- 5 deg
Determine fuel +/- 100lbs
PPC
Recompute
FAT+/- 5deg
PA +/- 1000’
Gross weight +/- 500 lbs
ETF +/- 0.05
Calculate values within
Q +/- 2%
Weight +/- 500lbs
fuel flow +/- 100lbs
Airspeed +/-5 kts
Determine Dynamic in flight performance
When any of the following apply
Within 3000lbs of MAX ALLOWABLE GW
Increase of 1000’ PA
increase of 5degC
Read out
A/C GW
Max allowable GW OGE
Q required to hover at MAXGW IGE/OGE
MTA
Hover power check
Verify if exceeding GW
Verify aircraft GW
Have sufficient power for the mission (IGE/OGE)
VMC takeoff
Lane alignement +/-5deg
Ground track +/-5deg
A/C in trim above 50’
Abort/ETL point for level acceleration/rolling T/O
Fuel Check
Start within 10 mins of leveling off/entering mission profile
Close out 15-30 mins after starting
Compute +/- 50lbs
Slopes
Select a suitable landing areas
Set parking brake
Heading +/- 5 deg
Do not allow +/-3’ drift, 0 once touched down
Note hovering attitude
Be familiar with dynamic rollover
Roll on landing
Select a suitable landing area
maintain a constant approach angle clear of obstacles
Maintain ground track with landing direction
Below 60KGS, +/-5 deg of landing dir
Autorotation
Rotor within limits
Airspeed within limits
Aircraft in trim +/- 1/2 ball
Suitable landing area
50-75’ AGL decelerative attittude
Basic hover standards
Heading +/- 10deg(20AFCS off)
Altitude +/-3’(5OGE)
Drift to not exceed 3’ in any direction(10’OGE)
Maintain ground track within 3’
basic In-flight standards
Heading +/-10deg
ALT +/- 10’
AS +/-10’
maintain rate of climb +/-200’
maintain trim +/- 1/2 ball
