AMG Flashcards
- What are the area dimensions required to perform MO&E for the AMG?
D 10 * 10
- Which CM(s) receive(s) the confirmation for march order?
D all CMs
- What is the width of the brush guards when in the down position on both sides?A
18 feet
- Which crew member connects the ground cable?
CM 1
- How long does the unit have to achieve their directed alert state?
60 minutes
- What device is used to obtain the AMG vehicle heading
Compass
- If the AMG is parked on a soft surface, the upper stabilizer strut should be aligned with the
_________ mark on the height guide.
Soft soil
- When lowering mast a safety switch automatically stops mast from moving lower than ________ degrees?
10
- Patriot Fire units and Battalion headquarters and headquarters batteries must maintain a minimum _______ AMG crew(s).
B one
- Ground rods must be driven to a minimum depth of __________ to provide an effective ground.
D 9 feet
- The ground rod should be located no farther than _________ from AMG ground connector.
C 15 feet
- What is the max tolerance for level and cross-level for the AMG?
B 10 degrees cross roll & 1/2 degree roll
- When polarizing roadside and curbside antennas, how many quick release pins need to be removed for each antenna?
B 4
- How long does the AMG crew have to install guy wires?
D not timed
- Which crew member maneuvers the AMG truck to the designated position?
A cm 1
- Where should the operator stand when obtaining the vehicle heading?
A front of vehicle
- During high winds, AMG masts must be retracted when…
D all of the above
- How does the AMG masts extended in the vertical position?
B automatically
- How are the AMG masts elevated to vertical position?
C hydraulicly
- If the AMG is emplaced on a hard surface, the upper stabilizer strut should be aligned with the _________ mark on the height guide.
A hard soil
‘21. Prior to elevating the priority mast, what should be connected?
B guy wires
- How long does the unit have to emplace the system and rejoin the air battle?
A 45 minutes
- Which crew member determines AMG heading?
B cm 2
- At what PSI does the air compressor shut off at?
A 90-95 psi
- The AMG should not be parked on grades exceeding what percent?
A 10
- What is the width of the stabilizer struts when fully extended to both sides?
B 16 feet
- What position must operators ensure mast extension switch is set to after mast is fully retracted to avoid draining the battery.
C pause
- How many personnel are required for the guy wire installation?
B 3
- Where are the AMG controls and indicators for mast warning lights and fault lamps located?
C distribution box
- What generator trailer model is towed by the AMG?
C PU-804
- What is the reference designator for the AMG truck mounted?
D 7
- At what PSI does the AIR PRESSURE indicator light illuminate?
B 80-85 psi
- What PSI should the regulator pressure gauge be set to?
A 35
- What is the approximate maximum height of the AMG masts?
A 81 feet
- How many antenna assemblies are on each of the telescoping masts of the AMG?
A 2
- When emplacing the AMG, the operator must position truck so there are no overhead obstructions, especially power lines. Mast shall only be raised at a horizontal distance of more than twice the maximum height of the mast from power lines.
A-true
- Before lowering the first mast, you must ensure that the other mast is one section higher than base.
A-true
- If freezing temperatures are expected, purge any water that may have collected inside the mast from rain or condensation by extending and retracting the mast several times.
A-true
- Mast group is cross leveled when the ball is centered in the green portion of the inclinometer.
A true
- Both mast can be raised and lowered at the same time.
B false
- What is BII?
BASIC ISSUE ITEMS
- What is UHF?
ULTRA- HIGH FREQUENCY
- In the ECS, what is used to monitor mast deflection (sway) and operational status of the AMG amplifiers?
ANTENNA MONITOR MAST PANEL
- What does PMCS stand for?
PREVENTITIVE MAINTENANCE CHECKS AND SERVICES
- What does AMG stand for?
ANTENNA MAST GROUP
- How many fire extinguishers are required for the AMG?
3
- Describe the 3 classes of leaks.
CL 1 WETNESS FORMS
CL 2 DROP FORMS BUT NO DRIP
CL 3 DROP DRIPS
- What is COEI?
COMPONENT OF END ITEM
- What gunnery table and technical manual cover PMCS for the AMG?
TM 11-5985-368-12P TABLE 1 SUBTASK 11
- What are the 3 types of PMCS that must be performed with each movement?
BEFORE
DURING
AFTER