Aircraft Guns Flashcards
At what prescribed rate can an M61A1/A2 gun fire M59 series ammunition
4,000 to 7,200 rpm
What components are the primary parts of an M61A1/A2 automatic gun
Barrels , rotor assembly , and housing assembly
What means are used to secure the gun barrels to the stub rotor of an M61A1/A2 automatic gun
Interrupted locking lugs
On an M61A1/A2 gun , what component picks up a round as it enters the gun
Breech-bolt assembly
On an M61A1/A2 gun , a full firing cycle requires what prescribed number of actions
Seven
What are the two distinct cycles of an M61A1/A2 automatic gun operation
Firing and clearing
What components of an M61A1/A2 automatic gun ejects the empty case from the gun
The extractor lip
On an M61A1/A2 automatic gun , what sequence of actions is performed by the breech-bolt assembly during one full firing cycle
Feed , chamber , lock and fire , unlock , extract , and eject
A drum unit assembly consists of the drum unit and what other major parts
Entrance cover , scoop disk , and exit cover
The mechanical drive unit in an F/A-18 aircraft had what total number of output shafts
One
A gun has purge system is used for what purpose
Cool the gun barrels and purge gas from the gun compartment
The air required to operate the gun gas purge system in an F/A-18 aircraft is provided by what air source
Engine bleed air and the ram air scavenge door
In an F/A-18 aircraft, the M61A1/A2 automatic gun system can be operated in what computer mode
A/A , A/G , or CCIP
In an F/A-18 aircraft , what component is used to manually clear the M61A1/A2 automatic gun
Clearing section clamp
An M61A1/A2 automatic gun must be sent to a depot-level maintenance activity under which of the following conditions
All answers are correct
A. When major repair is required
B. When an alteration is authorized
C. When 120,000 rounds have been expended
Which of the following gun maintenance procedures should be accomplished during scheduled maintenance
All answers are correct
A. Lubrication
B. Normal disassembly and parts replacement
C. A functional check of the components based on the round interval
Scheduled maintenance for an M61A1/A2 automatic gun handling and drive system should be performed after what maximum number of rounds has been fired
30,000 rounds
What is the rapid rate of fire for the GAU-21
950 to 1100 rounds per minute