Aerobatics Flashcards
Give the entry parameters and manoeuvre limits for a loop.
Entry speed = 230kts
Max Power
Minimum of 2000ft above base at apex.
State the parameters given as a rule of thumb for achieving base height in the final stages of a looping manoeuvre.
About 60 degrees nose down with 2000ft to go.
About (30-)40 degrees nose down with 1000ft to go.
Give the entry parameters and manoeuvre limits for a wing over.
Entre speed = 230kts
Max Power
Minimum speed at apex = 120kts.
For looping manoeuvres, what is the minimum speed at the apex?
100kts (check this).
Give the entry parameters and manoeuvre limits for an aileron roll.
Entry speed = 230kts
Power setting = 70%TQ
Give the entry parameters and manoeuvre limits for a Half Cuban.
Entry speed = 230kts
Max Power
Minimum of 2000ft above base at apex.
Give the entry parameters and manoeuvre limits for a Half Horizontal.
Entry Speed = 230kts
Max Power
Minimum of 2000ft above base at apex.
Give the entry parameters and manoeuvre limits for a Barrel Roll.
Entry Speed = 230kts
Power setting = 80% TQ or greater.
Give the entry parameters and manoeuvre limits for a Roll off the Top.
Entry Speed = 250kts
Max power.
Give the entry parameters and manoeuvre limits for a Half Roll and Pull Through.
Minimum Entry Speed = 140kts.
Minimum Entry Height = 2000ft above base.
Roll inverted, then set throttle to IDLE.
Give the entry parameters and manoeuvre limits for a quarter clover.
Entry Speed = 230kts
Max Power
Minimum of 2000ft above base at apex.
What is the maximum permitted time of continuous zero g flight?
5 seconds.
What is the maximum continuous inverted flight time?
60 seconds.
State the positive g recovery periods following periods of sustained (>15 seconds) negative g.
With >200lbs of fuel in each wing tank: 30 seconds.
With <200lbs of fuel in each wing tank: 60 seconds.
Give the entry parameters and manoeuvre limits for a slow roll.
Entry Speed = 200kts
Power setting = 60% TQ