Advancement Flashcards
1
Q
Information and guidance necessary to manage a uniform policy of maintenance and repair of ships is provided by which of the following programs?
A
QA
2
Q
The QA manual for the surface fleet describes what level of QA requirements?
A
Maximun
3
Q
The instructions in the basic QA manual are general in nature for which of the following reasons?
A
Because there is a wide range of ship types, equipment, and resources available for maintenance and repair
4
Q
What are the two key elements of the Navy’s QA program?
A
Administration and Job execution
5
Q
Which of the following goals are NOT common to all Navy QA programs?
A
6
Q
The QA program for COMNAVSURFLANT
includes a total of how many levels of responsibility?
A
7
Q
The QA officer (QAO) is responsible directly to which of the following officials?
A
8
Q
The QAO has which of the following responsibilities?
A
9
Q
The ship quality control inspector (SQCI) has all of the following responsibilities EXCEPT which one?
A
10
Q
Which of the following terms are often misunderstood in the field of QA?
A
11
Q
QA consists of a total of how many levels of quality verification requirements?
A
12
Q
What QA level provides the least amount of quality control?
A
13
Q
QA covers all events from the start of a maintenance action to its completion.
A
14
Q
On board ship, what is the primary vehicle for record keeping?
A
15
Q
Which of the following engineering logs are considered to be legal records?
A
16
Q
An error in the Engineering Log is corrected in what way?
A
17
Q
After the CO signs the Engineer’s Bell Book, no changes can be made to the book without permission from what authority?
A
18
Q
On a gas turbine–powered ship, which of the following logs are commonly used for recording and maintaining data necessary for proper water conditions in d waste heat steam plant?
A
19
Q
Which of the following boiler water and feed water logs should contain the boiler safety valve settings?
A
20
Q
For which of the following fuels are the fuel quality requirements more critical and extensive than for the other fuels?
A
21
Q
Which of the following activities must maintain marine gas turbine records?
A
22
Q
Which of the following NSTM chapters includes the procedures for maintaining marine gas turbine equipment service records (MGTESRs)?
A
23
Q
Which of the following activities starts the MGTESR?
A
24
Q
When a GTE is removed from the ship, what happens to its associated MGTESR?
A
25
A standard MGTESR binder consists of what total number of separate sections?
26
In which of the following sections of the MGTESR binder can you find a chronological record of nonrepair activities where the GTE was installed?
27
A GTE start should be recorded on the MGTE Operating Log for which of the following events?
28
Which of the following entries are NOT made on the MGTE Inspection Record?
29
In what section of the MGTSR are engine lay-up procedures recorded?
30
What authority prescribes the required forms a ship must use to account for the daily fresh water and fuel usage?
31
At what interval does the CO receive a fuel and water report?
32
When verifying operating records, you should check for all of the following details EXCEPT which one?
33
What is the quickest form of written communication used in the Navy?
34
What method should ships use to notify the NAVSEACEN or TYCOM of no urgent matters pertaining to PMS?
35
The instructions for preparing and submitting a PMS feedback report (FBR) located in what part of the report?
36
While performing PMS on a piece Of equipment, you notice a specific tool is required that is not listed on the PMS card. What category block on the PMS FBR should you use to indicate this discrepancy?
37
The number of entries allowed on a single EGL page is restricted to the number of work items that can be completed within what maximum number of work days?
38
Which of the following diagrams will show the individual connections within a unit and the physical arrangement of the components?
39
Which of the following diagrams will show the outlines of a ship and the location of connection boxes and cable runs?
40
Because they represent more complex circuitry and systems than electronic prints, electrical prints are more difficult to read.
41
What are the two types of logic diagrams?
42
Which of the following logic diagrams will show specific pin numbers, socket locations, and test points?
43
On gas turbine-powered ships, what is the purpose of a battery backup system?
44
How is the rapid method of transferring the load to the battery backup system accomplished?
45
On the CG-47 class ships, the UPS system can supply a nominal value of (a) how many volts dc for the duration of (b) how many minutes?
46
On DD-963 class ships, the UPS system consists of what type of storage batteries?
47
On a CG-47 class ship, an alarm will sound at the EPCC when the UPS battery voltage drops below what minimum value?
48
On a CG-47 class ship, a discharged UPS battery bank can be recharged within what minimum number of hours?
49
On a DD-963 class ship, what is the input power to the battery charger?
50
On the CG–47 and DD–963 class ships, the UPS batteries are connected in what configuration?
51
On a CG-47 ship, noncritical loads are shed by the internal power supplies after the UPS system has been operating a total of how many minutes?
52
On the DDG–993 class ship, the
battery charger circuit is electrically interlocked with the UPS battery room ventilation system for what primary reason?
53
The UPS system on which of the following ship classes contains a 120–V dc to 120–V ac inverter?
54
The UPS system on the FFG–7 class ships is located in what compartment?
55
The UPS system on the FFG–7 class ships consists of (a) how many storage batteries rated at (b) how many volts each?
56
On the FFG–7 class ships, which of the following modes of the UPS system can be selected by using the mode switch?
57
On the FFG-7 class ships, to prevent damage to the UPS system inverter, 120 V dc must be applied to the oscillator before the 120 V dc is applied to the inverter.
58
On a DDG-51 class ship, which of the following consoles is NOT protected by the UPS system?
59
On the DDG-51 class ships, the UPS battery cells will last what maximum period of time?
60
On the DDG–51 class ships, what are the power requirements for the MCS consoles?
61
On the DDG-5l class ships, the UPS can supply a nominal value of how many volts?
62
On a DDG-51 class ship’s UPS, the normal 3–phase voltage is rectified to the proper dc voltage in what component?
63
Specific gravity of battery electrolyte increases during discharge and decreases during charging.
64
You can determine the state of charge of a sealed battery by using what method?
65
What is the proper electrolyte level of an UPS storage battery?
66
To remove accumulated battery acid, you should wipe the case clean with a cloth moistened with which of the following solutions?
67
In what year was the USS Oliver Hazard Perry (FFG 7) commissioned?
1976
68
When was the gas turbine rate established?
October 1, 1978
69
In what year was the first gas turbine propelled craft commissioned into the United States
Navy?
1966
70
What document should be used in directing or reporting operation of all propulsion plant
equipment?
Engineering Operational Sequence System
71
When the throttles are in local control, who is responsible to carry out engine orders from the
officer of the deck (OOD)?
ERO
72
What information is contained in Volume I of the Manual of Navy Enlisted Manpower and
Personnel Classifications and Occupational Standards, NAVPERS 18068(series)?
73
What forms the foundation of a well-planned system that dovetails your training, advancement, and job assignments?
74
What publication will give you information for the construction, operation, maintenance, and different pieces of equipment?
Manufacture's Technical Manual
75
Who administers the Navy advancement exams on board ship?
Educational services officer
76
What document lists the ship’s plan/ship’s blueprints?
SID Ship's Drawing Index
77
What maintenance action form reports deferred maintenance actions and completed
maintenance actions?
OPNAV 4790/2K
78
What title describes 200 Section of the Personnel Qualification Standards?
Systems
79
What Naval Education and Training (NAVEDTRA) manual contains information on the duties and responsibilities of Personnel Qualification Standards qualifier?
NAVEDTRA 43100-1(series)
80
Regarding visual observations, which of the following statements defines the term clear?
The absence of solid particulate matter in an oil sample
81
Which of the following statements describes viscosity?
Viscosity is defined as a fluid’s resistance to flow.
82
What item prohibits operation or removal of equipment that can jeopardize safety of personnel or endanger equipment, systems, or components?
Danger Tags
83
At what maximum level, in decibels, must personnel wear approved double hearing protection?
104db
84
What voltage circuit causes the most shipboard electrocutions?
115 VAC
85
Profuse sweating, pale and clammy skin, a fast and weak pulse, fast and shallow breathing, dizziness, and nausea are some of the symptoms for what heat illness?
Exhaustion
86
When underway, what individual signs the Remarks section of the Engineering Log?
Engineering officer of the watch
87
Regarding entries into the Engineering Log, which of the following statements is true?
Entries should be written legibly in ink.
88
When the Engineer’s Bell Book is maintained by bridge personnel, on ships equipped with
controllable reversible pitch propellers, who signs the Engineer’s Bell Book?
Engineering officer of the watch
89
Using Ohm’s law, what is the total voltage for an electric circuit, if the circuit is 2 amperes with 6 ohms of resistance?
Ohm’s law can be stated mathematically by saying I=E÷R where: I=current in amperes (A), E=voltage in volts (V), and R=resistance in ohms (Ω). Ohm’s law can also be expressed in the following manners:
* R=E÷I
* E=I×R
90
Who extended the use of Ohm’s law by developing a simple concept concerning the voltages contained in a series loop?
Gustav Robert Kirchhoff
91
The amount of voltage generated depends on the following factors:
* Strength of the magnetic field
* Angle at which the conductor cuts the
magnetic field
* Speed at which the conductor is moved
* Length of the conductor within the magnetic field
92
Methods of Producing Electrical Power
Magnetism
Voltage produced in a conductor when the conductor moves through a magnetic
field, or when a magnetic field moves through the conductor in such a manner as to cut the magnetic lines of force of the field
93
Methods of Producing Electrical Power: Friction
Voltage produced by rubbing two materials together
94
Methods of Producing Electrical Power
Pressure (piezoelectricity)
Voltage produced by squeezing crystals of certain substances
95
Methods of Producing Electrical Power
Heat (thermoelectricity)
Voltage produced by heating the joint (junction) where two unlike
metals are joined
96
Methods of Producing Electrical Power
Light (photoelectricity)
Voltage produced by light striking photosensitive (light sensitive)
substances
97
Methods of Producing Electrical Power
Chemical Action
Voltage produced by chemical reaction; such as with a battery
98
The total number of magnetic lines of force leaving or entering the pole of a magnet is called...
magnetic flux
99
