Water Shuttle/Water Relay Flashcards

1
Q

In a water relay, if a combination of LPP and appliance pumps are used, where should the LPPs be sighted?

A

Nearest to the water supply

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
2
Q

How would an insufficient flow when relaying be improved?

A

Shortening distance between pumps using more intermediate pumps

Or

Increasing the diameter of the hose used

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
3
Q

What does the distance between pumps in a relay depend on (list of 3)

A

The flow rate required
The diameter of hose lines between pumps
The contours of the relay route

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
4
Q

How many lengths of 70mm apart can intermediate pumps be on a relay?

A

8 lengths on flat ground

6 lengths on a 10% incline

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
5
Q

How many lengths of hoselayer 90mm apart can intermediate pumps be on a relay?

A

15 lengths on flat ground

12 lengths on an incline

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
6
Q

At what bar pressure should an intermediate pump supply the foreground pump?

A

2 bar pressure.

This can be increased upon request up to a maximum of 15 bar.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
7
Q

The fireground pump operator must adjust the inlet valves to determine the correct flow and to try and maintain …(how much water in the Mark 3 flow meter)?

A

Between half and 3 quarters (when the autofill valve is fully open)

How well did you know this?
1
Not at all
2
3
4
5
Perfectly