TPC 319

Question 1

The best materials for filling around a foundation are

Answer 1

Gravel and ground concrete slabs

Question 2

Which type of reinforcing steel bar holds in the concrete best?

Answer 2

Deformed

Question 3

An inner plastic liner in a concrete form is used to

Answer 3

Create a smooth finish

Question 4

To isolate anchor bolts when mounting equipment on pads, surround the bolts with

Answer 4

Neoprene tubing

Question 5

What type of wrench should you use for tightening anchor bolts?

Answer 5

Torque

Question 6

To drill anchor bolt holes larger than 1^1/_2 in, you should use a

Answer 6

Core bit with a diamond or carbon tip

Question 7

Grout must be used within __________ of mixing.

Answer 7

15 minutes

Question 8

To smooth an exposed area of grout, you should

Answer 8

Cover it with mortar

Question 9

What is the least number of rollers you should use under a load on a skid?

Answer 9

3

Question 10

If you have no clearance to remove a sling after setting the equipment down, you should

Answer 10

Lower the equipment onto wedges

Question 11

What should you do with existing equipment’s lubricant and coolant when moving the equipment?

Answer 11

Drain and discard

Question 12

To support a level on an inverted V-shaped way, use a

Answer 12

Precision v block

Question 13

The common dial indicator is usually used with a ______ base.

Answer 13

Magnetic

Question 14

When an alignment screw is finally set, you can prevent further movement by

Answer 14

Applying a sealing compound

Question 15

Which of the following does not have the accuracy needed to level equipment?

Answer 15

Bench level

Question 16

When using a wire mike for checking vertical alignment, the weight should be

Answer 16

Suspended in a pail of light oil

Question 17

Which of the following is true for aligning mating parts on a piece of equipment?

Answer 17

Use one reference point for all parts

Question 18

A mechanic’s level is precise enough for aligning

Answer 18

Conveyors

Question 19

If the fluid in a system is thick, you can control it with a ______ check valve.

Answer 19

Ball

Question 20

You can keep the fluid pressure in a line near a preset level with a _____ valve.

Answer 20

Regulating

Question 21

A copy of the manufacturer’s test data is often attached to the ______ of new equipment.

Answer 21

Manual

Question 22

High temperatures during equipment start-up is usually caused by

Answer 22

Poor lubrication

Question 23

The temporary filters used for flushing a lube oil system should have __________ the permanent filter.

Answer 23

A larger capacity than

Question 24

Which term is used to describe starting and stopping a newly installed motor to ensure it rotates in the correct direction?

Answer 24

Bump

Question 25

Which of the following should not be used as a covering to keep poured concrete from freezing?

Answer 25

Salt