Texan EKQ Flashcards

1
Q

How many safety pins should be fitted in each cockpit when you check the aircraft before flight?

A

2

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
2
Q

Where are the CFS pins stowed and what procedure should be adopted?

A

CFS pin box. Close after each opening.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
3
Q

Below what battery voltage should an internal start not be attempted?

A

23.5V

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
4
Q

If during the initial checks battery voltage is less than 22V what should you do?

A

Batt off, déclare aircraft US, return to Ops

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
5
Q

Describe the AUX BAT test sequence and Pass/Fail criteria

A

Hold test button for 5 secs, ensure light remains illuminated for duration

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
6
Q

How do you know that external power has been connected to the aircraft?

A

Watch ground crew, check voltage 24-29.5V

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
7
Q

What must be disconnected before engaging the GEN after engine start?

A

GPU

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
8
Q

How do you know if the aircraft safety interlocks are in place to ensure a safe start sequence?

A

ST READY caption

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
9
Q

What is the max permitted ITT during a start cycle and for how long is that temperature allowed?

A

1000 deg C for 5 secs

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
10
Q

List 6 reasons why you would manually abort an engine start?

A

1 no rise of ITT within 10 secs of FF
2 ITT likely to exceed 1000
3 ITT likely to remain 871 to 1000 for more than 5 secs
4 Normal N1 increase halted
5 BATT BUS caption
6 ST READY extinguishes
7 PMU FAIL or PMU STATUS during start sequence
8 HYD Pressure remains at 0 during start sequence

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
11
Q

What is the max IOAT for an engine start?

A

80 deg

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
12
Q

How many start / dry crank cycles are permitted and what is the cooling period required

A

4

1 - 20 secs - 30 secs
2 - 20 secs - 2 mins
3 - 20 secs - 5 mins
4 - 20 secs - 30 mins

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
13
Q

What is the max permitted take off mass?

A

6900 lbs

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
14
Q

What is the max wind speed for opening or closing the canopy?

A

40 kts

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
15
Q

What is the max tailwind for landing?

A

10 kts

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
16
Q

What is the max crosswind for take off and landing (aircraft limit)?

17
Q

What is the IAS / Mach no limit for a clean aircraft?

A

316 kts / 0.67M

18
Q

What is the Max speed for flap extension?

19
Q

What is the max speed for extension of the landing gear?

20
Q

What are the minimum heights for practising stalling and Aeros?

A

Solo 5000 AGL
Dual 4000 AGL

21
Q

What is the max fuel asymmetry for Aeros?

22
Q

Texan G limits (clean and configured, symmetric / asymmetric)

A

Clean -3.5 to 7 / -1 to 4.7
Configured 0 to 2 / 0 to 2

23
Q

After sustained neg g operation, how long must elapse before further applications?

A

60 secs if less than 200lb per side
30 secs if greater than 200lb per side

24
Q

What is the max permitted time for intentional zero g flight?

25
Heights for spinning: MAH MHCR MEH Max EH
MAH: 3000 agl MHCR: highest of MAH + 4000, 11,500 AMSL, cloud tops + 4000 MEH: MHCR + 500 per turn Max EH: 22,000 AMSL
26
What is the incipient spin recovery drill?
Check height sufficient Idle 2 hands on control column, centralise When rotation stops, roll level, pull out from dive
27
What is the full spin recovery drill?
28
What is the best glide speed (clean and gr down)?
Clean 125 Gear down 120
29
What are the cross check min threshold speeds for LDG flap, TO flap, Flapless?
LDG flap - 100 TO flap - 105 Flapless - 110
30
If not cleared to land, what is the min height to go around?
150
31
If cleared to land with one landing ahead, what is the min spacing required on touchdown?
3000 or 1500 in formation
32
What are the limits for crossing an arrester cable, which is raised and supported?
Walking pace, avoid supports
33
What is the max permitted non manoeuvring inverted flight time?
60 secs