TEST 41-60 Flashcards

1
Q
Question No : 41 -
After successfully authenticating to a remote server, a server administrator is presented with an interactive command line with no graphical interface. Which of the following protocols did the administrator MOST likely use to securely connect to the remote server?
	• A.SSH
	• B.Bash
	• C.Telnet
	• D.FTP
A

A.SSH

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
2
Q
Question No : 42 -
Which of the following is the MOST secure to erase data before disposal of server hard drives?
	• A.Hard wipe
	• B.Reformat
	• C.Degaussing
	• D.Delete partitions
A

C.Degaussing

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
3
Q

Question No : 43 -
A server administrator is setting up a new set of hosts for an application that requires communication between all the hosts on a dedicated private subnet. Initially, the
configuration consists of four hosts and is expected to grow to 48 total as the application is implemented for the entire company. When configuring the private subnet, which of the following CIDR net masks would allow for the full number of hosts once the application is
fully in production with the least number of unused addresses allocated?
• A./25
• B./26
• C./27
• D./28

A

B./26

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
4
Q

Question No : 44 -
Which of the following is a reason to have a remote cold site readily available in case of a disaster in the primary datacenter?
• A.It provides a company with a redundant location that mirrors the primary datacenter hardware but requires no data restoration.
• B.It provides a company with a backup location to install the necessary equipment to restore critical services.
• C.It provides a company with a backup location equipped with resources necessary for immediate restoration of critical services.
• D.It provides a company with a redundant location that mirrors the primary datacenter hardware and data.

A

B.It provides a company with a backup location to install the necessary equipment to restore critical services.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
5
Q
Question No : 45 -
A technician is assigned a task to configure a new server with six hard drives. The senior administrator requested the technician utilize the drives for maximum fault tolerance. Which of the following RAID configurations should the technician use?
	• A.RAID 3
	• B.RAID 5
	• C.RAID 10
	• D.RAID 0
A

C.RAID 10

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
6
Q

Question No : 46 -
A technician is installing a rack mounted server into a rack in a datacenter with CRAC units and blanking panels. Blanking panels are used to:
• A.lower the UPS power requirements.
• B.limit airflow leakage in the rack.
• C.limit the amount of servers that will fit into the rack.
• D.color match the server color.

A

B.limit airflow leakage in the rack.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
7
Q
Question No : 47 -
An administrator is asked to change a configuration using a GUI on a Windows server, but does not have access to a KVM. Which of the following is BEST to make the change?
	• A.SSH
	• B.SCP
	• C.RDP
	• D.NTP
A

C.RDP

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
8
Q
Question No : 48 -
An administrator has a UPS rated at 200 amps per hour. Which of the following is the maximum run-time of this UPS when hooked up to a server drawing 400 amps per hour?
	• A.15 minutes
	• B.30 minutes
	• C.60 minutes
	• D.120 minutes
A

B.30 minutes

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
9
Q
Question No : 49 -
A system administrator is given a server with an existing OS installed and four empty SAS bays. The system administrator is asked to set up a new data drive for testing with 100 GB of data. For the best possible performance, which of the following should the system administrator select for the data storage?
	• A.SCSI
	• B.SATA
	• C.Solid state drive
	• D.Flash drive
A

C.Solid state drive

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
10
Q
Question No : 50 -
Two technicians are asked to install a 6U server at location U25 in a 40U server rack. The rack has been properly stabilized to the floor. Which of the following tools would BEST be used to install the server?
	• A.A static strap.
	• B.A server lift.
	• C.A PDU.
	• D.A UPS.
A

B.A server lift.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
11
Q

Question No : 51 - A server technician in a datacenter configures a daemon to monitor the battery health in a
UPS. Over a two day time period, the daemon Generates a warning message. Which of the following represents the FIRST action that should be taken by the server technician?
• A.Perform a test on the UPS batteries
• B.Immediately replace the UPS batteries
• C.Move the servers connected to the UPS to another existing UPS
• D.Immediately replace the UPS with a new UPS

A

A.Perform a test on the UPS batteries

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
12
Q
Question No : 52 -
An administrator is securing a secure web server by disabling ports. After completing this process, clients cannot access the secure web server. The administrator should now go back and verify whether which of the following ports is enabled?
	• A.23
	• B.389
	• C.443
	• D.445
A

C.443 HTPPS

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
13
Q
Question No : 53 -
A network administrator is tasked to set up zoning for a SAN infrastructure that requires redundancy. Which of the following types of hardware should the administrator implement?
	• A.Multiple VLANs
	• B.Multiple host nodes
	• C.Multiple HBAs
	• D.Multiple routers
A

C.Multiple HBAs

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
14
Q

Question No : 54 -
A technician is tasked with creating servers that are fault tolerant and highly available.
Which of the following would be the BEST solution for this task?
• A.Load balancing
• B.Virtualization
• C.Clustering
• D.Round robin

A

C.Clustering

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
15
Q

Question No : 55 -
A system administrator has decided to create several VMs for a company. In which of the
following locations would each of the VMs reside?
• A.Host
• B.VNC
• C.Guest
• D.VPN

A

A.Host

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
16
Q

Question No : 56 - A system administrator is tasked to enable authentication on a web server’s login page.
One of the requirements for the web server is to encrypt authenticated sessions over HTTP protocol for all static HTML pages. Using the information supplied, which of the following default port numbers should be used to satisfy these requirements?
• A.53
• B.8080
• C.143
• D.443

A

D.443

17
Q

Question No : 57 - A server in a small company functions as a print server. Suddenly it stops sending print jobs to the printers. A technician verifies that the printers are working correctly. Additionally, the print spooler had been restarted and is running on the server, it is accessible from workstations, and it shows as being ready to accept print jobs. Which of the following has MOST likely caused the print server to stop processing print jobs?
• A.The print quota has been exceeded.
• B.The server needs an updated print driver.
• C.The server needs pooling enabled.
• D.The server’s hard drive is out of space.

A

D.The server’s hard drive is out of space.

18
Q

Question No : 58 - A server technician is replacing a web server in an organization. The new server has two
integrated NICs. Which of the following describes how the NICs should be configured for fault protection?
• A.The NICs should be configured separately with one MAC address.
• B.The NICs should be placed into a team with one MAC address.
• C.The NICs should be configured separately with two MAC addresses.
• D.The NICs should be placed into a team with two MAC addresses.

A

B.The NICs should be placed into a team with one MAC address.

19
Q

Question No : 59 - A user in the accounting department reports that print jobs are not printing. A user in the
software development department also cannot print to the same printer, but can print to two other printers on different print servers. Which of the following should be the administrator’s FIRST step?
• A.Determine whether the server is out of virtual memory.
• B.Check whether the print spooler service has started.
• C.Reboot the print server.
• D.Have the users reboot their workstations.

A

B.Check whether the print spooler service has started.

20
Q
Question No : 60 - Which of the following describes a rack mounted server that is 2 rack units (2U) in height?
	• A.2.5 inches (6.35 cm)
	• B.3.0 inches (7.62 cm)
	• C.3.5 inches (8.89 cm)
	• D.4.0 inches (10.16 cm)
A

C.3.5 inches (8.89 cm)