Brainscape's Knowledge GenomeTM

Browse over 1 million classes created by top students, professors, publishers, and experts.


See full index

SERVER + > TEST 181-200 > Flashcards

TEST 181-200 Flashcards

1
Q 
Question No : 181 -
While performing routine testing of a hot standby site located at a remote hosting center, a system administrator is unable to access one of the server operating systems to verify functionality. Which of the following is MOST applicable to access the host?
	• A.KVM over IP
	• B.RDP over HTTP
	• C.Secure shell
	• D.Serial console access
	• E.VNC
A

A.KVM over IP

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
2
Q

Question No : 182 -
A technician reads a hardware manufacturer’s blog indicating a critical firmware update is available for the company’s file server. Which of the following is the BEST course of action?
• A.Download and install a firmware update from a centralized server.
• B.Download the firmware update and test it on a VM.
• C.Download the firmware update and test it on a non-production server.
• D.Download the firmware update and run it on the company’s file server immediately.

A

C.Download the firmware update and test it on a non-production server.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
3
Q

Question No : 183 -
Which of the following is the MOST redundant power solution?
• A.Two power supplies, each hooked up to individual legs of one 3-phase circuit.
• B.Two power supplies, each hooked up to the same 1-phase circuit.
• C.Two power supplies, each hooked up to separate 1-phase circuits.
• D.One power supply hooked up to two 1-phase circuits.

A

C.Two power supplies, each hooked up to separate 1-phase circuits.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
4
Q 
Question No : 184 -
A system administrator has a database server that crashes at random times. No changes have been made to either the server's software or hardware. Which of the following is the FIRST step the administrator should take towards resolving this issue?
	• A.Establish an action plan.
	• B.Perform a root cause analysis.
	• C.Document the findings.
	• D.Identify the problem and scope.
A

D.Identify the problem and scope.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
5
Q

Question No : 185 -
A technician is upgrading the memory in a server. The server requires DDR3 Registered DIMMs. The server has four banks of three slots for memory and currently there is one 2GB module in each bank. When the technician attempts to add eight more 4GB modules
of DDR3 unbuffered ECC memory, the memory does not fit in the slots. Which of the following is the cause of this issue?
• A.In a bank, 2GB and 4GB memory cannot be mixed.
• B.The server cannot use ECC memory.
• C.The server requires fully buffered memory.
• D.The total memory on the server cannot exceed 24GB of RAM.

A

C.The server requires fully buffered memory.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
6
Q 
Question No : 186 -
A system administrator has determined that more storage is needed for company data. The storage requires the highest speed data transfer rate with maximum performance. Which of the following solutions MUST be implemented to meet the business requirements?
	• A.FC SAN
	• B.FCoE
	• C.iSCSI
	• D.JBOD
A

A.FC SAN

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
7
Q 
Question No : 187 -
A datacenter is in a geologically active area and has no earthquake abatement installed. Which of the following drive types is BEST for general server use?
	• A.Solid state drives
	• B.High RPM drives
	• C.Low RPM drives
	• D.USB drives
A

A.Solid state drives

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
8
Q 
Question No : 188 -
A blade chassis can hold 16 half-height blades or eight full-height blades. Which of the following is the MAXIMUM number of half-height blades that can be installed in the chassis if six full-height blades are already installed?
	• A.2
	• B.4
	• C.8
	• D.16
A

B.4

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
9
Q 
Question No : 189 -
A technician is backing up 10 GB of data on a file server to a 250 GB external USB hard drive. After 4 GB has been backed up, the software generates an error that the size of The backup exceeds the file limit. Which of the following file system types is being used?
	• A.FAT32
	• B.NTFS
	• C.VMFS
	• D.ZFS
A

A.FAT32

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
10
Q

Question No : 190 -
A number of users are indicating that access to a network file server is responding very slowly when reading or writing to the share. The server administrator notes that a drive has failed in a four-disk RAID 5 array. The array is running in a degraded state because no hot spare was configured. After replacing the failed disk, which of the following steps would be BEST to take to prevent slow response after a drive failure?
• A.Add a drive to the array, but do not configure it as a hot spare.
• B.Add an additional hard drive, and convert the volume to a RAID 6 configuration.
• C.Add an additional hard drive, and convert the volume to a RAID 10 configuration.
• D.Add a drive to the array, and configure it as a cold spare.

A

B.Add an additional hard drive, and convert the volume to a RAID 6 configuration.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
11
Q 
Question No : 191 -
An administrator is tasked with deploying a server in a telephone switching station. Which of the following voltages will MOST likely be available at the facility?
	• A.-48VDC
	• B.120VDC
	• C.220VAC
	• D.440VAC
A

A.-48VDC

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
12
Q 
Question No : 192 -
When troubleshooting a failed backup, a technician runs the backup using the same tape but on a different tape drive in the same tape library. The backup fails again. Which of the Following should be the FIRST item the technician should examine as a failure?
	• A.Tape drive
	• B.Tape library
	• C.Tape media
	• D.Tape capacity
A

C.Tape media

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
13
Q 
Question No : 193 -
A server technician is investigating a potential data breach. It is believed that the breach occurred via telnet access. Which of the following could validate this hypothesis?
	• A.Port scanner
	• B.Cipher tools
	• C.Checksum analyzer
	• D.TDR
A

A.Port scanner

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
14
Q

Question No : 194 -
A network administrator is installing additional devices on the network. Currently, the network segment is utilizing all allocated IP addresses. If there are additional addresses available, which of the following would be BEST for the network administrator to perform to accommodate the new network devices?
• A.Create a new DHCP scope for the network segment in question.
• B.Configure the DHCP server for IPv6.
• C.Configure the network to use NAT for the network segment in question.
• D.Increase the size of the DHCP scope for the network segment in question.

A

D.Increase the size of the DHCP scope for the network segment in question.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
15
Q 
Question No : 195 -
An administrator needs to reconfigure a Linux servers operating system. Which of the following tools can the administrator use to access a command shell over the network? (Select TWO).
	• A.Connect with SSH
	• B.Connect with RDP
	• C.Connect with VNC
	• D.Connect with BASH
	• E.Connect with FTP
A

A.Connect with SSH

C.Connect with VNC

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
16
Q

Question No : 196 -
A server administrator is configuring access control on a file server for an organization. The Human Resources manager is taking a leave of absence for three months, during which time an interim Human Resources manager will take over the duties of the position. Which
of the following types of access control should be configured on the file server?
• A.MAC
• B.CBAC
• C.DAC
• D.RBAC

A

D.RBAC

17
Q

Question No : 197 -
A technician is installing an operating system on a server using source files on a USB storage device. The technician is unable to boot to the USB device using different USB ports on the server. Which of the following should the technician do to ensure that the
operating system can be installed from the USB storage?
• A.Copy the source files to a CD
• B.Install the latest USB device drivers
• C.Reconfigure the boot order
• D.Update the BIOS firmware

A

C.Reconfigure the boot order

18
Q 
Question No : 198 -
Which of the following factors would cause a technician to select a hard drive over an SSD
as a primary storage medium?
	• A.Speed
	• B.Power consumption
	• C.Form factor
	• D.Cost
A

D.Cost

19
Q

Question No : 199 -
Historical data shows that on average, a server is likely to fail once every nine months. A company has purchased 24x7, four hour hardware response to replace a server’s failed hardware. Additionally, the company can restore a server to its operational status within six hours from the time the failed hardware has been replaced. Which of the following
describes this scenario?
• A.The company’s MTTR is ten hours.
• B.Individual servers have 99.999% uptime.
• C.Service can be restored within four hours.
• D.The operational SLA is six hours.

A

A.The company’s MTTR is ten hours.

20
Q

Question No : 200 -
A server technician has been tasked with purchasing cables and connectors for a new server room. The server room consists of one switch, two servers, and one IP telephone. Which of the following types of cables and connectors should the technician purchase?
• A.Coaxial cable and BNC connectors
• B.Straight through Ethernet cable and RJ-45 connectors
• C.Silver satin and RJ-11 connectors
• D.Crossover Ethernet cable and RJ-11 connectors

A

B.Straight through Ethernet cable and RJ-45 connectors

SERVER + (11 decks)

Brainscape helps you reach your goals faster, through stronger study habits.
© 2024 Bold Learning Solutions. Terms and Conditions