Test 11/19 Flashcards
What should be done with all lock washers and screws with lock washer assemblies?
Replaced with new parts
How should over sized bearing bores be replaced?
It cannot, replace housing
What should be done to the housing if a ridge can be felt across the coil seat surface?
Replace housing
What is used to rework the inner face of the housing in the coil seat area?
A small grinding wheel or a chisel and Emery cloth
What should the reworked area be coated with?
Zinc chromate primer or Al paint
What should be done if corrosion or galling is present at the mating surfaces of the housings?
Replace housing
On the large distributor gear, there is evidence of looseness between the axle, gear and electrode. What should be done?
Reject the gear
Is there, and if so, what lubricant is applied to the inside of the distributor block?
Yes, Bendix Distributor Block Lubricant 10-391200
What should be done if the block is not marked with a raised boss or drill point indentation to the left and adjacent to the #1 high tension tower?
Remove the old lubricant
What do you do with coil core clamps not having an identifying dimple?
Replace with clamps that have identifying dimple
If the flyweights of the coupling assembly are riveted, can they be reused?
No
Even though the rotating magnet was found serviceable, what should be done to it prior to installation?
Should be charged before installation
If the magent turns with a feel of binding or rubbing, it is an indication of what?
Magnet shaft is bent
A small amount of oil on the shaft will help prevent what?
Damage to sleeve bearing
Where/what is the ground wire of the coil attaches to?
To magneto housing using screws with lock washers
