Study Guide: Fuel Flashcards
757: To reduce electrical loads, the center tank pumps are normally inhibited in flight or on the ground when:
a) Both crossfeed valves are open
b) The associated N2 is less than 50% RPM
c) The associated N3 is less than 50% RPM
d) The fueling bay door is open
The associated N3 is less than 50% RPM
757/767: According to the graphic, if the APU was not running, would these indications be normal?
No, the L FWD fuel pump PRESS light should be illuminated
757/767: Fuel is normally supplied to the APU from the left main fuel tank. While the APU is running, fuel is pumped by the:
Left forward fuel pump
757/767: Fuel is contained in a center tank and left and right main tanks. Additionally, located in each wing tip are surge tanks. Fuel from each surge tank is drained into:
The associated main tank
757/767: A fuel crossfeed VALVE light illuminates and the EICAS advisory message FWD FUEL X-FEED or AFT FUEL X-FEED displays if:
a) The crossfeed valve is closed
b) The fuel crossfeed valve is not in the commanded position
c) The crossfeed system is operating normally
d) The crossfeed valve is open
The fuel crossfeed valve is not in the commanded position
757/767: When center tank fuel is depleted, this will be indicated by:
a) EICAS caution messages L LOW CTR FUEL and R LOW CTR FUEL
b) EICAS advisory messages CTR L FUEL PUMP and CTR R FUEL PUMP
c) EICAS warning message LOW FUEL
d) There is no indication of center tank fuel depletion
EICAS advisory messages CTR L FUEL PUMP and CTR R FUEL PUMP
757/767: According to the graphic, all six fuel pumps are operating, therefore the ___ provide fuel to the engines.
Center tank
757: The fuel temperature (TEMP) indication displays the temperature of fuel in the:
a) Right main tank
b) Center tank
c) Left main tank
d) Left and right main tank, averaged
Right main tank
767: The fuel jettison system allows jettison from the ____.
Center tank
767: Two dual pump units provide a high capacity jettison rate of approximately ____ pounds per minute.
a) 2200
b) 1800
c) 2600
d) 1500
2600
763: Positioning the FUEL JETTISON selector to ON automatically ___ in order to reduce electrical demand.
a) Inhibits all window heat and configures equipment cooling to the override mode
b) Inhibits L-3 and R-3 window heat and configures equipment cooling to the standby mode
c) Inhibits all window heat and configures equipment cooling to the standby mode
d) Inhibits L-3 and R-3 window heat and configures equipment cooling to the override mode
Inhibits L-3 and R-3 window heat and configures equipment cooling to the override mode
767: The fuel temperature (TEMP) indication displays the temperature of fuel in the:
Left main tank
767: When fuel quantity in the left and right main tanks differ by 2000 pounds (plus or minus 500 pounds) the ________ light illuminates and the corresponding EICAS advisory message is displayed.
a) FUEL DISAGREE
b) LOW FUEL
c) FUEL BALANCE
d) FUEL CONFIG
FUEL CONFIG
757: When fuel quantity in the left and right main tanks differ by ___ pounds the FUEL CONFIG light illuminates and the corresponding EICAS advisory message is displayed.
a) 1600
b) 1500
c) 1800
d) 1200
1800
757/767: According to the graphic, the fuel configuration FUEL CONFIG light is illuminated. Which statement provides a possible cause for it’s illumination?
a) The center tank contains more than 1800 pounds and the center fuel pump switches are OFF
b) The center tank contains more than 1200 pounds and the center fuel pump switches are ON
c) The center tank contains more than 2000 pounds (plus or minus 500) and the center fuel pump switches are OFF
d) The center tank contains more than 1200 pounds and the center fuel pump switches are OFF
The center tank contains more than 1200 pounds and the center fuel pump switches are OFF