Steam Flashcards
Auxiliary steam at full operating pressure is supplied from the boiler directly to the
soot blowers
Which of the valves listed should be closed before lighting off a boiler?
Economizer drain valve
Which of the devices listed is indicated by arrow “H” shown in the illustration? SG-0008
Economizer
The major heat loss in an oil fired boiler is the heat __________.
going up the stack
According to the illustration of a typical boiler furnace rear wall, which item number would best represent “insulating block”? Illustration SG-0003
7
Boiler refractory firebrick is secured to the casing by __________.
slots in the brick engaging anchor bolts
Which of the listed refractory materials can be used in an area directly exposed to the highest heat in the furnace?
Firebrick
When you are installing a new furnace floor in an oil fired boiler, the clearance between the firebricks should be large enough to __________.
allow for expansion without subjecting the joint to flame penetration
In which of the listed components is chemical energy converted to thermal energy with regards to boiler operation?
Furnace
Recirculation of the feed water ensures a flow of water through the __________.
main feed pump
The device illustrated is referred to as a/an __________. GS-0048
inverted bucket trap
The function of the device illustrated is to __________. GS-0048
control condensate output from a heat exchanger
The quantity of condensate passing through the illustrated steam trap will be reduced as the __________. GS-0005
amount of vapor contained in “A” increases
The trap illustrated operates as a __________. GS-0005
thermostatic bellows type steam trap
If “E” is moved closer to the top of “B” as shown in the illustration, the __________. GS-0002
point of condensation will be moved closer to the steam inlet of the heat exchanger