Section 1 COMMON OCCUPATIONAL SKILLS

Question 1

1. During an inspection, the safety harness and the lanyard are in good condition, but only the safety harness is past its expiry date. What is done?

Answer 1

A. Use the lanyard and the harness as is.
B. Replace the harness and use the lanyard.
C. Use the harness and replace the lanyard.
D. Replace the lanyard and the harness.

Question 2

2. What is the procedure to replace a static pressure transmitter?

Answer 2

A. Depressurize, de-energize, replace, then isolate.
B. De-energize, isolate, depressurize, then replace.
C. Isolate, depressurize, de-energize, then replace.
D. Isolate, depressurize, replace, then de-energize.

Question 3

3. Refer to Figure 24. What is the primary temperature element?

Answer 3

A. Pyrometer
B. Filled thermal system
C. Thermocouple
D. Bi-metallic element

Question 4

4. A routine calibration is required on an explosive gas monitor, in which order are the tasks planned?

Answer 4

A. Select PPE, obtain work permit, then ensure parts are on hand.
B. Obtain work permit, select PPE, then ensure parts are on hand.
C. Identify correct safety procedure, obtain work permit, then select PPE.
D. Select PPE, obtain work permit, then identify correct safety procedure.

Question 5

5. Which test gauge is selected to verify the calibration of a mercury manometer with a measuring head of 25 in?

Answer 5

A. 0 to 30 in H₂O
B. 0 to 1 psi
C. 0 to 15 psi
D. 0 to 100 psi

Question 6

6. What is inspected before using multimeter?

Answer 6

A. The test leads.
B. The battery.
C. The fuse.
D. The screen protector.

Question 7

7. A transmitter has been permanently removed from service. How is this change identified on a P&ID?

Answer 7

A. By updating the changes in blue.
B. By updating the changes in red.
C. By making notations in the note section.
D. By highlighting the changes in yellow.