SCSI

Question 1

You just purchased an external SCSI hard drive for your desktop workstation. What should you knew before connecting to the system?

– Load the appropriate drivers for the drive the server Console
– Configure the driver as the master or slave on the bus
– Configure the drive in servers BIOS
– Set the drives SCSI ID

Answer 1

Set the drives SCSI ID

Question 2

You’re configuring devices on SCSI bus. You’ve installed a SCSI adapter in expansion slot. You’ve connected an external SCSI tape drives to the external port connector on the adapter . You’ve connected two a hard SCSI hard disk drives (sd0 and sd1) to two of the middle connectors on the internal SCSI ribbon cable. The end connector on the internal SCSI ribbon cable is connected to a SCSI DVD drive. Where should termination be enabled on the bus? (Select two)

– On hard drive sd0
– On hard drive sd1
– On either hard disk drive
– On the external tape drive
– On the DVD drive
– On the SCSI adapter

Answer 2

On the external tape drive

On the DVD drive

Question 3

Which of the following types of SCS I termination using voltage regulations in conjunction with resistors to terminate the SCS I bus?
– LVD determination
– Passive termination
– HVD termination
– Active termination

Answer 3

Active termination

Question 4

Your desktop workstation system use the SCSI bus to connect storage devices. The SCSI host adapter in the assigned ID 07, the SCSI hard disk is assigned an ID of 5, the SCSI tape drive is assigned an ID of 3, and the SCSI DVD drive and assigned an ID 0. What device has the highest priority on the SCS I bus?

Answer 4

Host adapter

Question 5

A SCSI hard disk drive has three jumpers that are used to set the SCSI ID. Shunts been placed on the first and third jumpers. What SCSI ID has been assigned to this device?

Answer 5

5