Rotor and Drive

Question 1

During the power up initiated (BIT), chip cautions should not appear. However, if one or more chip detectors fail the (BIT) a __ caution will appear

Answer 1

a. CHIP IBIT FAIL

Question 2

Which of the following is a characteristic of the UH-60M rotor system?

Answer 2

a. all of the above (articulated rotor system, wide chord blades, rotor brake)

Question 3

The Intermediate and Tail gearboxes may run at cruise flight for up to __minutes with loss of all oil.

Answer 3

30 min

Question 4

MAIN XMSN PRESS Caution Appears / MAIN XMSN OIL HOT Caution Appears. Loss of cooling oil supply will lead to electrical and/or mechanical failure of the

Answer 4

a. main generators

Question 5

Fuzz burn is a feature that is available on all of the transmission chip detectors, but only the main module chip detector has

Answer 5

a. 30 second delay

Question 6

T/R QUAD FAIL caution, with loss of control, indicates that both cables have failed, in which case, a ____. will position the tail rotor servo linkage to provide __ of pitch

Answer 6

a. centering spring, 10.5 degrees

Question 7

What is the purpose of the elastomeric bearings located within each main rotor spindle assembly?

Answer 7

a. Permits each blade to flap, lead, and lag

Question 8

The rotor brake should never be applied

Answer 8

a. With NR above 76%

Question 9

Engine power control levers are blocked from being advanced past the idle position when the

Answer 9

a. rotor brake is engaged

Question 10

What is the purpose of the main rotor blade dampers?

Answer 10

a. Limits the lead and lag of each main rotor blade.