PARKING and SHUTDOWN W, C, N

Question 1

PARKING AND SHUTDOWN

Answer 1

PARKING AND SHUTDOWN

Question 2

1-16

APU CONT switch- ON.
The APU ON, BACK UP PUMP ON, and APU ACCUM LOW advisories- Appear
2N

Answer 2

N. External Power (if needed) = Connect and EXT PWR switch RESET
N. No AC power= Shutdown #2 Engine first

Question 3

1-21

ENG POWER CONT levers- IDLE
1W 1C

Answer 3

W. Move levers slowly when tailwheel lockpin is not engaged
C. Keep Cyclic neutral, Collectible no more than 1in Up, Pedals centered

Question 4

1-24

Droop Stops- Verify in, about 50% NR
1C 1N

Answer 4

C. Don’t increase collective
N. if Droop Stops don’t go in lower NR. If still not, accelerate to 75% NR. displace cyclic if still not, keep everyone clear and drive on.

Question 5

1-29

ENG POWER CONT lever(s)- OFF after 2 minutes at NG of 90% or less
1C

Answer 5

C. Engine needs to cool for 2 min at NG 90% or less before ENG POWER CONT lever OFF.
HIGH PWR (above 90%): if needed to restart without cooldown you have 5 minutes, if not you wait 4 hours before start.

Question 6

1-33

DEC/EDECU signal validation fault codes- Check
2N

Answer 6

N. No power= No codes
N. Q value DEC/EDECU codes can be found in FMS STS page

Question 7

1-39

GENERATORS APU switch- OFF
1N

Answer 7

N. After turning GENERATORS APU OFF, wait 15 sec then turn EGI 1 and EGI 2 OFF